Xcal 2 problem

[Mattstang04]

Ive had my xcal2 for quite a while but really only used it for my axle ratio change. I wanted to reset my rev limiter to a lower setting and realized that without my stock settings I have no limiter. Has anyone else had this problem? With the stock settings everything is fine, it hits the stock limit at 6000 rpm. As soon as I change to the performance tune and adjust my perameters, no rev limiter at all. The speedo change works, my reset idle speed works, as well as timing tweeks, but it voids the freakin rev limiter in drive and idle. Thanks ahead of time.:SNSign:

 

[02nightmaregt]

Not sure if they are the same but i know with my old predator i could go in and modify the performance tune.

 

[Mattstang04]

I can change the parameters but as long as the performance tune is installed, no matter what rpm I set the rev limiter to, it just doesnt work. Take the tune out and the stock limiter works fine. I dont understand, could it be a programability issue with my ecm?

 

[Tim2002GT]

Maybe there is a problem with your end user rights to that tune. I would contact whoever you got the tune from and have them email it back to you with the correct rpm you want for the rev limiter.