zex tc window switch install

Discussion in 'Fox 5.0 Talk' started by tyler08, Mar 14, 2009.

  1. tyler08 New Member

    Member Since:
    Feb 4, 2009
    Message Count:
    16
    Likes Received:
    0
    Trophy Points:
    0
    where do I splice into to get my tach signal?
    tyler08, Mar 14, 2009
    #1

  2. bubba-dough Active Member

    Member Since:
    Dec 29, 2004
    Message Count:
    1,056
    Likes Received:
    1
    Trophy Points:
    38
    Location:
    Indiana
    If you do not have an MSD ignition box then it goes to the negative coil wire. Just come back a few inches off of the harness that plugs into the coil. If you do have an MSD ignition box then use the tach port off of it.
    bubba-dough, Mar 14, 2009
    #2

  3. tyler08 New Member

    Member Since:
    Feb 4, 2009
    Message Count:
    16
    Likes Received:
    0
    Trophy Points:
    0
    ok thanks for all your help so far!!
    tyler08, Mar 15, 2009
    #3

Share This Page