Media

The nasty little 306 is done and pulls hard

front to back drivetrain like new

Yes, everything that was removed that wasnt brand new was repainted

Worl Class T-5 Trans rebuild

That 3/8 hose is actually an extra intank pickup hose I had, when the pump is mounted here its the perfect fit to the filter

fuel pump wusing stock plastic supply line slid over a barbed nipple works perfect and almost looks factory

More harness assembly

Custom harness creation begins

MSD 6AL Box

Empty bay starting from scratch

Engine built but before install

Pretty large ports for small block heads

Stock paint painted and hammer clearenced for Canton windage tray

struts & the cc plates

SN95 spindles, holding 03 rotors, dual piston PBR calipers, Hawk pads, MM ss brake lines, MM bump steer kit, Lakewood 70/30's and Eibach prokit springs

Flamming River manual rack

The 31 spline Moser axled rear I built that houses 4.10's and an 8 clutch disc posi, had drums on it in the pic, now its rocking disc brakes.

k member wire wheeled and painted

Rear suspension consisting of Eibach springs (4 cyl's now), MM double adj uppers, UPR lowers, Lakewood 50/50 and full length subframes.

mustang rear

mustang front

29

10

6