Search results

info is listed here- http://www.austinsvt.com/sanantonio

would they be the same on a 94/95?

I'm guessing it's coming from above vs. wheel wells since it has not been driven on wet roads in 6-7 years.

I removed the trunk liner from my '95 and found 4" of water in that side pocket area that would be below the gas fill inlet. Same on the other side too :( Put a hose to it all around the trunk/rear window/tails and didn't notice it coming in anywhere. Any ideas, is this a common thing?

Are the airbags fine to unplug with the battery unhooked? (and are they ok to go back in the same?)

any tips/tricks to make the swap a little less painful? :nice:

The '93 Cobra R used 13" brakes and had the same 17" tri-bar wheels (brakes are not the exact same as 94-04 but close)

sorry, you can't have it back :) It will soon be canary yellow for my '95 Fobra R The wiring for your 3rd brake may look hacked/tapped then cause the two different lids had a slightly different plug (as I found out when looking at the light in the cobra spoiler vs. stock stang light in the lid)...

I start with getting the lock knob through the top and align the bottom hooks into the holes then guide it to go over the top ledge it sits in. Make sure there are no 'extra' screw tabs hanging off the new speaker that may be blocking the door panel from seating correctly.

looks clean overall, rear bumper looks like it's been hit/tapped (the gap under the lights and trunk lid is way out) And the tail light on drivers side doesn't line up with the trunk lid.

I need the passenger side version of the trunk wall/section pictured (plus those two clips seen there that hold it in place there at the back seat opening) Also have a pic of the other section from the trunk I'm needing. (mine was cut up) If you have them, what condition are they in...

My tint on both windows have scratches from the guides/pads, before I put new tint on (this stuff is 8yrs old) I want to replace these. * Can you just buy these new? * Can I just peel off the material and replace? * What is the soft material if I do replace it?

I am looking for this plug/grommet/cap. On a 94/95 It's under the carpet on passenger side on the boxed frame section (there is actually two of them there, I'm missing one). (pictured) Also could use - Passenger side Trunk liner section (hard/formed carpet wall) The long metal clip that...

I wanted to know if anyone with the Opal gral interior has swapped to a Gray 1998 Console that had cup holders and mainly, was it the same shade of gray??

I wanted to know if anyone with the Opal gral interior has swapped to a Gray 1998 Console that had cup holders and mainly, was it the same shade of gray??

Looks good, only thing I would change is the font style on Supercharged, I would have it match the font on the pace car on the door.

I'm removing all of this mess (keeps leaking, was on car when I bought it, gauges coming out too). How was the stock sending unit installed? Just it by itself screwed into the block? Is Permatex High Temp Thread Sealant (59214) the right stuff to use on it?

$200 is a bargain. Price out just one at your local Ford parts counter ($285 EACH!)

we have 1" spacers and the stock studs do hang out some but the wheels (stock machs and frpp black bullitts) clear them fine. May depend on the wheels your running.