Yesterday the bearing in my alternator went bad so I decided to upgrade it with a 3G 130Amp alternator.
I've read through several walk-thru's, including this one: http://www.stangnet.com/mustang-forums/646825-3g-alternator-install-how.html
The problem I'm running into is that the '86 is a Btard year.
I ran a 4g lead from the post to the starter 'noid, ground down the bracket, ect. Now it's an electrical problem. I'm missing wires.
As you can see I don't have the stator wire coming from the D connector.
I was wondering if I could use the green/red wire that's on the middle of the plug as the stator wire because of this pic:
Photo by Katmandu
and this pic:
Photo by [email protected]
Or if there is a how-to for '86s I'd really appreciate it.
I've read through several walk-thru's, including this one: http://www.stangnet.com/mustang-forums/646825-3g-alternator-install-how.html
The problem I'm running into is that the '86 is a Btard year.
I ran a 4g lead from the post to the starter 'noid, ground down the bracket, ect. Now it's an electrical problem. I'm missing wires.
As you can see I don't have the stator wire coming from the D connector.
I was wondering if I could use the green/red wire that's on the middle of the plug as the stator wire because of this pic:
Photo by Katmandu
and this pic:
Photo by [email protected]
Or if there is a how-to for '86s I'd really appreciate it.