i have been using the T fitting that i got with my mongoose kit. i have it tied in at the back pass side of the vehicle right where MPH told me to put it. now that i finally have my new bov it isnt opening with the engine veccum at idle. i can press it open easily but it will not open on its own. it is causing the car to shut off at idle. i tried a few vac lines closer to the engine and they seemed a little stronger but still didnt open it. i am currently running the 11# spring
Spring Rate: 11 PSI(-22 in/Hg)
Use: Engine Vacuum Reading: -18 to -21 in/Hg
is this too much pressure?
what do i need to do?
Spring Rate: 11 PSI(-22 in/Hg)
Use: Engine Vacuum Reading: -18 to -21 in/Hg
is this too much pressure?
what do i need to do?