ok, so before i start peicing all of the parts together i just wanted to make sure that this is a project i can handle by myself so i found the manual for the M 2300 K Kit online and started reading through it. so now i have a couple questions
first i read that you need a welder to attach the "paw" to the emergency brake handle. do i really need a welder for this? about 2 years ago i replaced the emergency brake cable and don't remember anything called a "paw" even.
also i have about 27 inches of clearance(from the cap on my wheels) on each side of my mustang and i noticed that the axles are just under 30 inches in length. i am not sure when i remove the wheels and drums how much space that will give me but do you think that will be enough for me to slide the axles in and out?
so before i start with this project, is their anything you guys can think of that i should consider?
Thanks for any info
first i read that you need a welder to attach the "paw" to the emergency brake handle. do i really need a welder for this? about 2 years ago i replaced the emergency brake cable and don't remember anything called a "paw" even.
also i have about 27 inches of clearance(from the cap on my wheels) on each side of my mustang and i noticed that the axles are just under 30 inches in length. i am not sure when i remove the wheels and drums how much space that will give me but do you think that will be enough for me to slide the axles in and out?
so before i start with this project, is their anything you guys can think of that i should consider?
Thanks for any info