Search results

  1. toyman

    High Fan And Pin 17

    I suspect my high fan isn't switching on. Note that I'm running an AEM-EMS. However, if I ground pin 17 with a cold engine should I expect the fan to come on or would it only come on at or above its set temperature? It doesn't come on (cold) but there is a "click" sound as if a relay is being...
  2. toyman

    Member Location

    Just noticed that when you click on a members location you are directed to Google Maps. Did this just start?
  3. toyman

    Digital Dash - Finally Got It To Work

    I bought this dash about 4 years ago but never got around to installing it. Tried late last year but ran into a number of issues that couldn't be resolved at the time. The big issue was that the system shut down the auto transmission control function in the EMS. As Nordskog closed their doors a...
  4. toyman

    Where is it?

    For the life of me I can't find a wiring reference for the cruise control module. Can someone point me in the right direction. I need to tap into the signal wire from the module for my digital dash to work with the AODE.
  5. toyman

    Transmission Flaring

    Does anyone know what the primary cause of flaring is? I suspect it's the shift solenoid or something similar. Just started immediately after I swapped out the gauge cluster. I can't see any connection between the two events but thought I should ask.
  6. toyman

    LED Bulbs for 94 cluster warning lights

    Can someone give me a link for LED warning ( ABS, Parking, Seat belt. et al) bulbs. The bulb number appears to be 37. They are a lot smaller than the 194 dash illumination bulbs.
  7. toyman

    High Speed Fan Control

    I just discovered that my High Fan is not coming on. I can hear a click from the CCRM when I back probe pin 17 to ground and a steady clicking when I try to switch it on through the EMS. Need some clarification on manually overriding the control relay to verify that the fan will come on high...
  8. toyman

    Calculating HP

    I've wondered what my car is putting down to the rear wheels without the benefit of a dyno. The formula to calculate HP is: HP= (Nc * injector rating * duty cycle)/ bsfc Where Nc = Number of cylinders and bsfc = brake specific fuel consumption. The bsfc for a supercharged engine running...
  9. toyman

    Mach 1 Caliper Install/Upgrade

    I have purchased a set of Mach 1 calipers with brackets and was wondering if there is anything else needed other than the 13" rotors. Earlier posts made reference to kit M-2300-Q but that part is no longer in the FRPP catalog. Was that a rotor and caliper kit or did it include other hardware?
  10. toyman

    Painted Mirrors Pics

    I need to have my rear bumper painted and am thinking of having the mirrors done at the same time. Any pics of matching colors and/or regrets?
  11. toyman

    Header Thoughts

    I'm still pushing the exhaust through the stock headers. Mods in sig. Will there be any real advantages to changing the headers and if so, is there one recommended for my setup? I would prefer to keep the existing mid pipe and catback system.
  12. toyman

    I want Santa to bring me one of these

    One can only say WOW http://members.shaw.ca/r-manders/my_new_car.pps
  13. toyman

    Absolutely Horrible around town MPG

    For starters I'm running an AEM-EMS. I'm lucky if I see 8 mpg around town. I've pulled fuel and increased timing in the low load load cells to maintain a 14.7 AFR running in closed loop. The O2 target error and feedback values are as close to zero as one can get. What I'm interested in knowing...
  14. toyman

    Headers Glowing Red

    I wanted to open this thread again as someone mentioned not too long ago about his headers glowing. As I have been experiencing higher than normal engine coolant temps I was curious about my headers glowing. In daylight it isn't obvious but at night they are glowing slightly on both sides just...
  15. toyman

    Door Mirror Vibration

    Before I take the mirror assembly apart (if it can come apart) has anyone been successful in eliminating the slight movement in the mirror that occurs while driving. I'm thinking it may be as simple as a loose mounting screw but I haven't tried to disassemble the mirror. I find that rapid...
  16. toyman

    Cooling

    I've been having cooling issues since installing the KB when in traffic with high ambient air temperatures and under high load conditions (temps in the 220*- 230+ range). As I'm running a cobra crank pulley (5.85") vs the stock pulley (6.875") it occurs to me that perhaps I should install an...
  17. toyman

    AFR vs ECT

    Whenever I change the AFR to 14.7 at idle and low load the ECT increases to about 220* vs 195* at AFR 14.0. Ambiant air temp is about 80*. Does this make sense? Low fan is on at 190* and high at 220*. I know that the leaner burn will be hotter but this seems out of whack. I'm using 94 octane...
  18. toyman

    I Need Stealth

    I just recently added Magnaflow Hi-Flow metallic spun cats and a Magnaflow cat back system. Problem is I can be heard from a mile away and I want quiet. Tried a Dynamax muffler today and it was no better and perhaps worse. And while I know most of you want that deep rumble but that's not what...
  19. toyman

    Where did the horses go??

    I finally got onto a dyno and I'm trying to figure out why my tune isn't delivering the numbers I would have guessed. 274 rwhp @ 5000 rpm and 356 ft-lbs of torque. AFR avg 11.7 (11.0 - 12.3). Max boost 8.04 psi. Results are from a Mustang Dyno. Seems pathetic given the mods in my sig. I was...
  20. toyman

    Magnaflow 3 1/2" Tips

    I just installed a complete cat back magnaflow system and have a couple of questions. Is it me, or are the 3.5" tips just too big? Second, does the exhaust sound normally resonate to the point of creating vibrations throughout the car or is that just because all the hanger bushings are new?
Top Bottom
Back
Forums
Menu