Search results

  1. 93GreenLX

    cancel

    bump
  2. 93GreenLX

    Rear Suspension Options....?...?..?...?

    I'm hopefully picking up a rear in the next couple of days and ditch my 7.5 Drum to drum and I think it still has GOOD E-brake cables Trac-loc with 10,000ish miles on rebuild. I think they are FMS gears. Complete with brakes and all!!! 3:73 with welded axle tubes That an edited...
  3. 93GreenLX

    New Radiator?

    I've got a new 200amp pa perf. alternator in, about to order underd drive pullies and a DCC Mark VIII fan setup 3018-M I think it is. I have an AOD with a bolt on modded only 302. Should I go ahead and replace the 160K Mile radiator while I'm at it? If so whats my best bet for an easy drop in...
  4. 93GreenLX

    DCC Fan/Control Combo...which one?

    I'm looking to get a kit from http://www.dccontrol.com/ What exactly is the difference between the 3018-M and the 3018-E I have a 93 2.3<5.0 converted with an 88 5.0 HO 200 amp alternator and will be getting underdrive pullies. Is there anything ewlse I need to get from them to...
  5. 93GreenLX

    compatible instrument clusters?

    I have a 93 2.3 that I converted using an 88 5.0. I used the 88 engine harness. Now I am in need of a new instrument cluster. I'd like the oil pressure and temps to be somewhat accurate....lol What options do I have and what's by best choice? Thanks. I'd spend a couple hundred if it meant...
  6. 93GreenLX

    2.3 to 5.0 converted Rack

    Hey there boys , haven't been on in a while...(3 kids will do that to you) At any rate I need new inner tie rods. For the price I might as well get a new rack. I have a 93 2.3 to 5.0 converted car with the stock 2.3 rack/lines etc. What upgrade options are available to me, I get a pretty...
  7. 93GreenLX

    Anyway to make the 2.3 dash work??

    I 'm done with my 2.3--->5.0 swap and the tach and speedo read way off, this I'm sure can be fixed with the correct speedo gear. However, the oil pressure and temp gauges do not work. The fuel gauge works fine. Will my 2.3 dash work fine or do I need to swap it out for a 5.0 dash
  8. 93GreenLX

    Just finished 2.3->5.0 swap. EGR question???

    I don't have a vacuum line attached to the back of my EGR and don't see anything that looks like it should go there. Everything else is plugged in and I don't HEAR any vacuum leaks. I have pinging during moderate, heavy acceleration. Its a stock 88 5.0 with MAF conversion. BBK CAI, BBK shorties...
  9. 93GreenLX

    Just finished 2.3->5.0 swap. EGR question???

    Delete Delete Doiuble Post
  10. 93GreenLX

    Helllpppppppp with 5.0 swap

    I've got a 93 LX 2.3 and am swapping from an 88 GT 5.0. All wiring is being used from the 88 from the computer forward. Everything is done(basically) went to turn her over and there's no fuel pump whining. Also should the coil be hot(not temperature type) when cranking because its not. It's...
  11. 93GreenLX

    Help a newb with his flow pipes

    I've got BBK shorties and a MAC O/R H-Pipe installed and lined up fine. The problem is that the flow pipes are different and it says nowhere which one goes on which side. I have looked at pictures and think that I have it right but I can't get the cat back lined up perfectly for the life of...
  12. 93GreenLX

    5.0 Swap Power Sterring/Fuel pump question

    I'm swapping an 88 GT 5.0 into my 2.3 93 car and can't find anything on whether or not I have to swap the fuel pump or the power steering pump. Also what about the accelorator cable does it need to be swapped?
  13. 93GreenLX

    Debating on dumping Exhaust

    Hey guys, I was debating on getting rid of my pacesetter longtube header. I have the full exhaust for the 2.3 and might get rid of it all in my 5.0 swap. the muffler and tail is reusable but I'm debating switch to Mac. Would anyone even be interested or should I reuse it?
  14. 93GreenLX

    2.3 to 5.0 cluster swap question

    What all is needed to swap the instrument cluster from an 88 GT into my 93 2.3. I am about half way through my 4 to 8 cyl conversion
  15. 93GreenLX

    5.0 A/c hoses/lines the same as 2.3

    I'm installing my 2.3 A/c stuff on the 302 during the swap but my question is whether the lines and other hardware are the same. I know that I will have to get an A/C bracket, but other than that???? Anyone done this before?
  16. 93GreenLX

    2.3 Parts that are compatible on 5.0?

    Is the rack and pinion the same on both cars? Appearance wise they look exactly the same. Also my donor car is an 88 with out A/C and my 93 2.3 has A/c. What needs to be done/can it be done? to make it all hookup. Last thing is the radiator. The donor cars radiator is a little messed up...
  17. 93GreenLX

    Cougar AOD ???

    I'm going to be temporarily hooking up a Cougar AOD from an 87 or 88 in place of the stang AOD, is there anything I need to be aware of? Anything need fabricating? Will it work fine? Thanks Nikk
  18. 93GreenLX

    Job of the 2-3 Accumulator?

    What exactly does the 2-3 accumulator do?
  19. 93GreenLX

    Dropping Valve Body tomorrow.....

    Tomorrow, I am going to pull the valve body out and thoroughly check it out to see if it is the cuprit. I am going to replace the upper and lower gaskets, too. Anything else I need to be aware of?
  20. 93GreenLX

    C4, C6 AOD Any others?

    Are there any other auto trannys that will bolt up to a fox 302? :shrug: I may have a free c4 coming my way if I cannot easily fix the AOD. Also anything different about hooking up the C4 than the AOD?
Top Bottom
Back
Forums
Menu