Search results

  1. G

    Car runs like garbage,.....

    I was hoping that somebody here could at least point me in the right direction. I drove my car this morning to the doctors and noticed that it was running extremely sluggish. Starting in first gear, the car takes off extremely slow until I reach around 2k rpms, then when I shift into each...
  2. G

    Transmission/shifter vibration at low rpms

    I have a 95 mustang with all stock parts other than a cold air intake. I have some problems with the trans/shifter vibrating at low rpms. When I take off in 1st gear the transmission shakes alot up until i get to about 1500 rpms or so. Same when i am in 2 - 4 gears as well. When I shift into...
  3. G

    Missing vacuum line?.............

    I have been having a high idle problem for some time now. I just brought my car over to a friends house where I can work on the car. I pulled off the liner inside the passenger fender to get to the charcoal canister and check the vacuum lines. I followed one of the hoses comming from the...
  4. G

    Very High Idle Problem

    Hello, I have a 95 manual trans v6. I've had a high idle problem for a while, and over time it keeps getting worse, and worse. About a year ago the high idle was around 1500rpm. I have cleaned the maf, iac, throttle body etc. Over time the idle became higher and higher to around 2800rpm with...
  5. G

    CAI Problems - weird noises - bad startup/shutdown

    I recently got a CAI off of ebay. Put the intake on my car no problem except for a slight modification to the hole for the IAT sensor. I had to drill it out to make it a tad bit bigger so the IAT sensor would fit. Ok, well my problems are as follows: 1. When I start the car, the car...
  6. G

    Wiring question for the electrical guru's.....

    Ok, I'm trying to trace a problem that I'm having. I keep blowing a fuse under the dash of my 95 3.8. The fuse is #18. This fuse is listed as the fuse for the CCRM, ignition coil(coil pack), regulator signal(voltage regulator) and charging system warning lamp. I started to trace the wire...
  7. G

    What should display on the instrument panel....

    When I KO/EO my 95 Mustang, I have the check engine light and charging system warning indicator(battery) light on at the instrument panel. Is this normal? What should be illuminated when you key on/engine off the car?
  8. G

    95' PCM swap to a 96"+ PCM?

    I was wondering if you could swap a 95 model PCM with one from a 96+ year mustang so that I can eliminate the need to have the ICM. Has anyone ever done this?
  9. G

    Will this ICM work ??

    I just realized that this ICM that I got from my buddy is out of a 4 cylinder coutour. It looks exactly the same, and has the same model number on it as the one out of my 95 mustang. I am wondering if it should work in my car because I was thinking that mine was bad......Does anyone know if it...
  10. G

    Firing orders.....

    I was looking in my chiltons manual, and I found it odd how the firing orders are for my 95 Mustang. It is also the same way on Autozone's website: http://www.autozone.com/images/cds/gif/medium/0900823d801da94c.gif I thought on the coil, the top three wires were right, but I thought the...
  11. G

    95' V6 ignition coils....Replace twice in one year?

    I have a 95 v6 mustang, I was driving my car last night, dogged on it, then it starting acting pretty ****ty. Long story short, the car stalled, pushed it on the side, found out it was the ignition coil, replaced it, running fine now. I replaced the same thing about 6 months ago. Is this a...
  12. G

    What rpm do you shift at?

    I was wondering what rpm you all shift at. I still have a stock 95 mustang manual trans, other than the 99+ factory cobra clutch I just put in there. I usually shift around 2k for normal driving, and if I want to get on it, I try to go no higher than 3k, because around 3k, my car kinda stops...
  13. G

    3.8 V6 Clutch size???

    Does anyone know what size the clutch and flywheel is for a 95' Mustang 3.8 V6? I need to replace mine, and even the guys at Autozone don't even know what size the clutches and flywheels are for my car, and I don't want to buy the wrong size and not have them fit. Any help would be greatly...
  14. G

    Engine noise removed by stepping on clutch?

    I have a noise comming from my engine, I can't quite figure out what it's from yet, but I think it may be a loose belt or a loose pully. Not sure. Well anyways, I have a squeeking noise comming from my engine(when I'm parked, and when I'm driving), but if I just gently have my foot on the...
  15. G

    Use a supercharger off of an older T-brd?

    I was wondering if anyone has taken a super charger off of an older T-bird SC and put it on their V6 Mustang. The idea crossed my mind, and I was just a bit curious to see if anyone has done this before........
  16. G

    Car Alarm

    I know this may be stupid, but I can't get my car alarm to work anymore. It worked fine yesterday, but not now. I have a codealarm elite 1100. Usually when I press arm on my keychain keypad, I hear two chirps, and if I touch the car, or open a door without disarming, it goes off. Now, when I...
  17. G

    Check engine light, stang runs like crap......

    Today at work during lunch, my stang ran fine. I parked my car, went in to get a bit to eat, and came back out to go back to work, and my car wouldn't start. I checked all of the fuses under the hood, and under the dash, and the only one that was blown was fuse 18, for the EEC pwr. I put in a...
  18. G

    Installing a kill switch

    I'm new to the forums. I was wondering if anyone could tell me a simple way to install a kill switch. I have a 95' Mustang. Thanks in advance for any help.
Top Bottom
Back
Forums
Menu