Search results

  1. Mach1Run

    Need some trim pieces for a 07 GT.

    Picked up a 07 GT a couple days ago and need a couple of small bits. I need the little tab that goes on the upped back of the seat to tip it forward and the screw cap that holds the trunk liner that allows access to the tail lights. Anywhere to either get them online or look them up ahead of...
  2. Mach1Run

    Convertible quarter window gap

    How do you go about fixing this? Do I have to replace the little bushings or do I have to replace the guide post? And what is the best way to go about it, will I need to remove the frame for the top:ack:? Or hopefully would new weatherstrip pieces most likely fill the gap up correctly?
  3. Mach1Run

    Fluid for convertible tops.

    What kind of fluid should I use in the system that raises and lowers the top? A friend suggested hydrolic jack oil but want to see if anyone has a better suggestion.
  4. Mach1Run

    Convertible top issue

    93 LX vert Discovered that the piston on the passenger side that raises and lowers the top has started leaking fluid out the top so I need to replace it. I have a replacement on hand, but what is the best way to get to the old one to get it out and get the new one in? I have the interior panel...
  5. Mach1Run

    Replacing an oil pan gasket.

    93 LX Vert - stock 302 far as I can tell. What is the best way to do this? And what parts do I need? My skill level is late beginner/early intermediate and I dont have anyone with much experience to guide me other than what I can find on the net. I noticed some drips under the car the other...
  6. Mach1Run

    93 LX Vert - Top issues

    For my father's day present the wife found and got me a 93 LX convertible. Needs some time and attention but it runs good and the top doesnt leak. However the top does not work by itself, you have to put it up and down by hand, so that is going to be the first order of business. When you flip...
  7. Mach1Run

    Which of these lines is for the rear?

    Standing on the drivers side looking down at the proportioning valve with the master cylinder removed. I am suppose to remove the line for the erar but the picture my instruction have is crap and just show both lines without identifying one from the other. Is the line for the rear the one on the...
  8. Mach1Run

    Getting ready to install a line lock

    And I was doing some research. Seems supposedly the easy way is to go from the bottom and remove the line from the MC and the proportioning valve and slide the assembly up. My question, if I unscrew the line from the MC will it drain all the fluid from the MC or just what? Trying to figure out...
  9. Mach1Run

    Which CC plates do I need to look at?

    So I finally got around to lowering the Mach a week or two ago with some Eibach Sportlines. At first i thought maybe it would be able to be aligned with the stock plates but after 2 weeks to get them settled its pretty obvious I need CC plates. Question 1: Do I need 3 or 4 bolt plates or does...
  10. Mach1Run

    Using Predator to check TPS.

    Whats the best way to go about this? Select Diag mode then start the car, then select which report to get the voltage?
  11. Mach1Run

    Lowering the mach's nose.

    A while back I was considering lowering my car with either the eibach sports or HR super sports. Then I got to thinking about my what I really wanted out of the car as a whole and how I do not want to do any mods more than once if I can help it. Ultimately I think I will wind up going longtubes...
  12. Mach1Run

    o2 Sensor issues

    Had a 02 go bad on the mach and replaced it with a brand new Bosch part. Less than 1000 miles later and the CEL comes on again for the drivers side 02, which I just replaced. To make sure it was the sensor not something else, I swapped it with the passenger one and cleared the code with the...
  13. Mach1Run

    Predator Programing ?

    Driving home today I got the P0153 Slow o2 circuit response code. I have an o/r x and MILs and one of the buggers must have gone south. I would like to just turn them off if I can, but looking through the modify tune menu I wasn't sure if I need to turn the o2 sensors off or turn off the 2...
  14. Mach1Run

    Fox Shopping

    Going to look at this car in the morning. Anything I should look for in particular regarding 5.0s and Foxs? And other than tears what should I look at regarding the top and top motor? All the info I have on the car so far is below, no pics. And based on the info below what do you think a fair...
  15. Mach1Run

    Prep work to repaint a bumper.

    I bought a used bumper for my car that needs to be resprayed to get rid of some nicks and chips and stuff before I put it on. This is my first try at this sort of thing so please bear with me as I blunder along. It is already the same color that it is going to be repainted. What are the steps...
  16. Mach1Run

    Mounting fog light bezels.

    picked up a used 01 cobra bumper cover and bezels, but no foglights, today and cant figure out how to attach the bezels to the cover. Do I re-use parts off the stock cover or something?
  17. Mach1Run

    My cheap-o 86

    I have been looking for a fox roller for about a year now on the local boards and most of them are in the 1500+ range, but last monday I found a 1986 Vert with a c4 tranny and a non running 289 in it for $300. I figured for that price if I managed to blow it to pieces in the driveway I could...
  18. Mach1Run

    Part #

    Anyone know the part number for the 99/01 cobra front bumper cover?
  19. Mach1Run

    Mach 1 New wheels and window sticker.

    Finally got some tires to go on the wheels I got for christmas and a copy of my the window sticker that was on the car when it went to the original dealer! Pics could be better but I didnt have access to my good camera at the time.
  20. Mach1Run

    Mach 1 Oh Noes!

    I think i may have the dreaded tick. Going to have to have the dealer listen to it and pray they know what to do. Funny thing is it didnt show up until we started getting some much colder weather down here. No tick all summer, a few nights in the upper 20s and low 30s and now there is a sound...
Top Bottom
Back
Forums
Menu