Search results

Just like the title says, I would like to get these sideskirts repainted. How hard are they to take off without breaking? I have talked to a few body places and have been quoted $300-$500 for the job and that is just me bringing the car to them in the state that it is in. Now I was thinking...

The plastic trim piece that sits right below my rear window is badly faded and I was going to see if I could take it out and repaint it. Hopefully this can be done somewhat easily. Here is the piece I am talking about: Thank You.

My friend at work the other day gave me an Aeromotive AFPR to put on my car. I was just wondering if this is everything that I needed. He said that the piece coming off of it is for hooking up an electronic gauge in the car. Do I still check the pressure with the valve on the fuel rail or do...

So I bought this mustang back in 2007 and it had this sunroof installed. At the time, I knew very little about Mustangs and I quickly learned that they did not come from the factory with them installed. I think this may have been an aftermarket dealership option or something. I don't know...

A lady I work with just bought a new car and was going to junk her old explorer. I have to double check what year it is but if I could get the parts from it for dirt cheap would it be worth it? I just know it has the 5.0 liter engine in it. Would it just be the heads/intake? Is there even...

When I left work this afternoon I noticed this on my car :mad: : It could have happened while it was parked at my house (I live in a condo so we have a shared parking lot) or at work. I just know it had to of happened in the last couple of days. I will run through our security cameras at...

Just thought that I'd post some pictures I took while installing some new o2 sensors. So far so good. I took it on a little drive after the install and no CEL comes on now. Hopefully, this solved my issues.

Quick question. I am noticing what I think is an exhaust leak coming from my passenger side exhaust header. It sounds almost like a ticking noise and little spurts of air. I dont really hear it at idle, only when I am driving so I am pretty sure it is not a valve tick or anything like that...

And now I have yet ANOTHER problem with this car. The drivers side power window randomly stops working (usually when I have it down, go figure) but the passenger window works just fine. I took my panel off and used the multi meter to see if something was not getting power. The switches seemed...

I have a aode with a torque convertor that has about a 2k stall on it. When I go to put it into gear whether it be reverse or drive, the car almost stalls and dies. Is this an issue with my convertor? I am going to check/clean the IAC and check for vacuum leaks. Does anyone know what may be...

So I was double checking making sure I had the right firing order after doing a plug/wire install when I decided to take the cap off and look at the distributor. Here is what she looked like: Does this mean that I have to change the whole distributor or can I just do the cap and rotor like...

I'm just curious how anyone that has the BBK fendermount cai mounted the filter to the tube inside the fender. I struggled a lot doing this. Should I have dropped the fender wheel lining to make it easier? In the bbk install video it looked like they had theirs out when they did it. And then...

Sorry if this is a dumb question but today when I was installing my new wires, I noticed the set came with two different types of wires that connect the distributer to the coil. They both are a little different from the wire that was being replaced. I dont have any kind of aftermarket coil...

Today when I was cruising around I noticed that my vents would not blow air no matter what setting I had it on. Now I was under the impression that if it only blew air on the high setting, that meant a bad resistor. But if it didnt blow any air at all, that meant a bad motor. So, I decided to...

Well I got my car out of storage yesterday so now I can finally install the stuff I had sitting around for it: BBK Cold Air Intake 75mm Pro-M MAF 9mm Blue FRPP Spark Plug Wires New Spark Plugs Sea Foam Treatment Oil Change/Filter

Since I have to get my car out of storage in a couple of weeks I was planning on doing a tune up on it. When it comes to the oil, I wanted to go full synthetic and was planning on putting Royal Purple in it. But since I only drive it about 500 miles during the spring/summer would I have to...

About two years ago my car was randomly stalling on me (automatic transmission). When I took it into a shop to have it fixed, they told me that the problem was casued from a bad Mass Air Flow meter. I told them that I wanted it replaced with a aftermarket one and they suggested a Pro-M. So, I...

Hi I am finally getting some time to take my car out of winter storage (I know im getting a VERY late start on that) and am looking for some suggestions on what I should do right away as far as getting it ready for the summer. It is a 95 GT. I know the usual routine but am mainly concerned...

I have a 95 GT and I want to put a cold air intake on it. I have a couple in mind but not sure. I've heard good things about the 57 Series K&N FIPK kit. But I noticed that it uses the stock tube instead of a new one. Also, I do have a 75mm Pro-M MAF installed and I'm not sure if that makes a...