Search results

I got my new FRPP DS in the mail yesterday and i noticed the spline shaft female input is keyed, so i assume the male spline output shaft will be keyed also on the tranny? (See right side of spline) Also when installing do i need to apply some sort of grease to the spline or will it be lubed...

DENT PICTURES Was told by a Body shop PDR cant be done. Need opinions to either leave it or get body work done...

My drivers seat creaks like a mofo, cant tell if its an internal spring in the seat or the fram itself. Wondering if anyone has or had the same problem and if you did what was the cause?

Hi all, I have a stange front end creaking going on...it only happens when i step on the brake's while the car is moving foward (at any speed). I have put the car on ramps and went underneath and moved the car up and down and cant replicate the creak. It almost sounds like its in the dash...

I am in the process of installing my Steeda UCA....let me tell you what a PITA it is to get the old bushings out...I spent 6 hours today just to get one side done... i started on the other side but i am going to finish that on the morning..I had to drill....used a torch and then a wire...

just got a a KB K-Member brace new off ebay for $50, any one install one? easy or hard?

Thinking about getting these, what do you guys think? http://secure.50resto.com/product1.cfm?SID=1&Product_ID=1288&Category_ID=610

Wondering if its worth my time to instal it myself or have ashop do it and pay $80? What you guys think? i have a good set of tools.

Hi all, i want to buy Steeda UCS's to go along with there lowers i installed last summer. I noticed this past weekend i need them, gotta get ride if the sloshy rear. How difficult is the install? i know the bushings on the axle side are a PITA, any tips to make it easier to get them out? do i...

Ok no flames please... Now for my honest opinion for all your CAI no belivers....Believe.... I with out a doubt can feel the difference with the CAI installed over the stock K&N setup. Its not night and day difference like a gear swap but she revs up quicker and pulls a little stronger and...

I am loooking to do two mods this spring..the one i am most definate on is the MRT catted H but for the other these are my choices! 1. Steeda Tri-ax 2. Steeda UCA 3. Steeda CAI 4. Intake Plenum stock throttle body

I would like some opinions on canceling my extended warranty, i bough the extra 3/30k ...so its 6/60k i will have the car 3 years march 05, the car only has 13k miles on it...she is my weekend toy only..so should i cancel and use the $$ for mods or keep it just in case i break something 2 years...

http://www.blueovalnews.com/2003/cars/mustang.05.463gt.htm