Search results

*Ford Racing Boss 5.0 block, has been align honed with ARP fasteners (not side bolts), decks cleaned up, bored to 3.745". This block was meant to be set up at a 3.750" bore and we can finish hone (with torque plate) the block for whoever wants it. $1100 *Kellogg 3.800" crankshaft. $375 *Brand...

I had an ECC internal ground go bad, so I bought a new ECC from Autozone. They gave me an E9ZF DA and even though it started up quickly and idled well, the Check Engine light came on and told me that I had a code 22 -- MAP sensor. I never had problems with the MAP sensor before. Why all of...

I'm finishing up a C4 swap and I'm very confused. There is a 4 prong connector towards the front of the transmission and a 2 prong connector towards the middle of the trans. In the wiring schematic, it says the 4 prong switch is for neutral safety and backup lights. When I wired my...

Hey guys, I would appreciate any help with this as it's about to get me down. I just completed a T5 to C4 conversion. While in the process, I removed the clutch pedal, and jumpered both connectors that plug into the clutch pedal. Under the car, there were two connectors as well, a...

Well, I completed my coilover install this evening. It consisted of Strange adjustable struts, Strange coilover kits, and QA1 12-250 springs. Assembly was pretty easy and straightforward. The car is not a daily driver, but just a weekend toy. However, I'm not driving the car much at all until I...

They remind me of Bogarts, but they appear to be 17". Anyone know for sure?