Search results

  1. NJCstang

    Car is acting up when hot

    After doing a little digging I thing you are right. I belive my calbes are all 2 gauge. I am going to redo the both the positive and all the grounds with 1/0 cables. Would this be causing the issues with my oil? I would blame that on the stock gauge but since it started ticking on me I figured...
  2. NJCstang

    Car is acting up when hot

    I have a 90 LX with the 3G upgrade and the battery in the trunk. When the car warms up I have problems with the car. The oil pressure drops to zero, like the gauge isn’t getting any power. If I rev the engine the pressure raises for a second then drops again. I have not gotten a mechanical...
  3. NJCstang

    classic mustang project discussion

    I am looking for a weekend warrior, definitely not a daily driver but not an unreliable POS. It may see some track time but mostly just cruising around with the family. And hopefully the car will never see a trailer. I would like to find somehting that has the body work done already (if it still...
  4. NJCstang

    classic mustang project discussion

    I would like to get everyone's opinion on this since I am considering taking on a classic mustang as my next project. What are the pros and cons to working on a classic mustang? I would definitely be doing a restomod, I am thinking a 65 coupe would be really nice. Everyone chime in and talk...
  5. NJCstang

    Couple questions...

    I'll try to help a little. The small top post on the solenoid is for the ignition wire. It is just a push on connector. The terminal that you numbered three is for the starter wire. That side is not the ground but a switched source. When turn the ignition terminal three gets power. The solenoid...
  6. NJCstang

    Help with speedo issue

    I'll go through that list but can someone please help me figure out why my speedo doesn't work? I got a new cable cause the old one fried and the gear on the vss is in good condition. Is there anything else that I can look at? There are no codes for a bad vss. Thanks
  7. NJCstang

    Help with speedo issue

    Thanks for the answer. Do you have any idea where to start looking then? Does anyone else ahve any ideas?
  8. NJCstang

    Help with speedo issue

    I am having a couple of issues with my car that I am hoping are related. One problem is that the speedo does not work and the other problem is that when I come to a stop the car stalls unless I am giving it gas. The idle does not move more than 100 rpm normally and it does not stall all the...
  9. NJCstang

    v.s.s help

    What are the symptoms of a bad vss? Is there a way to test for a bad vss? Would a bad speedo cable cause the same problems as a bad vss? My speedo does not work in my car and after the car warms up it will usually kill on me unless I give it soem gas. The car starts back up with no problem...
  10. NJCstang

    car started but died need help

    I scanned the codes and got a code 51. Could that be causing this problem? I could not restab the dizzy because it was raining.
  11. NJCstang

    car started but died need help

    This might sound like a stupid question but does the spout need to be out when I stab the dizzy and try to get the car started for the first time? Once the car is running on its own then I can set the timing with a light and put the spout back in? I have not taken the spout out for this part...
  12. NJCstang

    car started but died need help

    Last time I checked for spark it was a nice blue spark. I'll check it again to be sure. I will check the codes again tonight and see if there is anything there. Thanks
  13. NJCstang

    car started but died need help

    Thanks for the help. I have followed the above steps about three times now. I try putting the distributor in again and see if that helps. But it won't be today because it is raining. If the above is correct then what else would cause this problem? Could it be the pip sensor?
  14. NJCstang

    car started but died need help

    I bought the car not fully assembled. I had to add the injectors, fuel line, intakes, and distributor. I get spark with the plugs out of the car and the car fires when I spray starting fluid in the motor but the car immediatly dies. The injectors are getting a pulse to fire (verified with a noid...
  15. NJCstang

    car started but died need help

    I have gone through the check list and finally got the car started last night. I had to turn the distributor a little to get it to fire but when I let go of the distributor the car died and would not start back. I tried to reinstall the distibutor but that did not help either. I feel like an...
  16. NJCstang

    Dumped codes... please help

    I have been trying to get my car running for a long time now and I think that I am very close. I have gone through jrichker's help a ton of times. I have fuel and spark and I am pretty positive that the timing is correct. When I try to start the car I kind of pops like it wants to fire but it...
  17. NJCstang

    fuel injector help

    I have been following the no start guide and I have figured out that the car is not getting fuel. I have fuel at the schrader valve but the engine is not getting fuel. The injectors have power to the red wire. I have not checked for injection pulse yet. The car did fire when I used a little...
  18. NJCstang

    HELP!!! WIRING ALTERNATOR MASTER DISCONNECT SWITCH

    I hate to hijack this thread but I have a similar problem. My master disconnect switch only has the two big terminals on it. Where does the alternator get wired to? I asked before and someone suggested the constant power side but when I try to crank the car the fuse pops. What could be the...
  19. NJCstang

    help with iginition switch issues

    With the key in the on position every wire ahows 12v except for the white/pink wire. And the ignition switch was changed over the weekend. This seems very odd to me. From my undertsanding of the wiring scematic power is coming in through the yellow wires and when the switch it acctivated it...