I went by and looked at the doors this morning ,the driver door was not repairable .The pass side only had a slight roll at the bottom front edge so i went ahead and took it ,at a discount of course .
A little hammer and dolly work and i had it looking good ,no bondo needed
I sprayed the spot with epoxy primer just to keep it from rusting
This is a Dynacorn door and it is very straight ,except for the shipping damage that is now repaired .
How it will fit up to the quarter and to the front fender ,i will have to wait and bolt it on the car to see.
I see two problems ,the grain finish on the inner part of the door is way to light ,it is almost smooth .It could be just heavy primer but i don't think so .I am going to blast it off gently .The way it is now if it were painted the grain would completely disappear .
The inside of the door has spots of bare metal showing so i will spray it with epoxy primer ,it will rust very quickly if it isn't primed .
Now i have to wait for the driver door ,and hope they do not damage it in transport .