I am starting the stang up after months of reconstruction. The car cranks however doesn't even make an effort to fire. I did remove the distributor to install an new intake. So possibly it may be off.
I also checked for voltage at the ignition coil and there is no voltage. Not sure why. I l then checked the TFI module and its getting voltage. Cap and rotor are fine, TPS is at .98v. What else do I need to check that I am missing? This very similar situation already happen to me the first time I fired it up about 1 year ago.
Jose
I also checked for voltage at the ignition coil and there is no voltage. Not sure why. I l then checked the TFI module and its getting voltage. Cap and rotor are fine, TPS is at .98v. What else do I need to check that I am missing? This very similar situation already happen to me the first time I fired it up about 1 year ago.
Jose