egr spacer required w/ rpm2?

[lietuvis91]

I got an edelbrock rpm2 intake and I baught a 70mm tb and the elbow from someone used. I am planning on taking off the EGR when I install the intake, so I was wondering if I still need to buy the egr spacer to get this thing bolted up or can I get by without it?

 

[ProKiller]

94-95 throttle body's don't have egr spacers. did you get a fox throttle body? If so then your going to need a lot more than that.

if still using a 94-95 throttle body and elbow. you'll need a 351cleveland fuel pump block plate. such as this: http://store.summitracing.com/partdetail.asp?part=MRG-1517&autoview=sku

i cut off the tube going to the header and used the nut over and put a penny in there. it's held so far.

 

[lietuvis91]

94-95 throttle body's don't have egr spacers. did you get a fox throttle body? If so then your going to need a lot more than that.

if still using a 94-95 throttle body and elbow. you'll need a 351cleveland fuel pump block plate. such as this: http://store.summitracing.com/partdetail.asp?part=MRG-1517&autoview=sku

i cut off the tube going to the header and used the nut over and put a penny in there. it's held so far.

Oh cool! The elbow and TB that I bought was off of a 94-95 car, so then I don't need the spacer!!! Dude, thank's for answering my question! You ROCK!