i found an 80mm Pro-M mass air meter calibrated for 24# injectors for a decent price and was wondering if this would be considered too big for my application? can i run "too big" of a meter? i'm rebuilding my motor with clevite 77 main and rod bearings, durabond cam bearings, power seal rings, felpro gaskets and ARP bolts on the internals. pretty much stock motor:
306 balanced and blueprinted
ross forged pistons
crane 1.6 rr's
cobra intake
65mm tb
24# injectors
cai
u/d crank
long tubes
2.5" o/r H pipe
spintech prostreets
4:10's
thanks guys!
306 balanced and blueprinted
ross forged pistons
crane 1.6 rr's
cobra intake
65mm tb
24# injectors
cai
u/d crank
long tubes
2.5" o/r H pipe
spintech prostreets
4:10's
thanks guys!