look mom no cats.

Discussion in '2005 - 2009 Specific Tech' started by mustangmike6996, Jan 21, 2007.

  1. mustangmike6996 Member

    Member Since:
    Nov 11, 2005
    Message Count:
    401
    Likes Received:
    0
    Trophy Points:
    16
    what does everyone recommend as far as off road X or H pipe? can you use mil elim or do you absolutly need a tune?

    i like the power i have now (all stock) but i want a little more noise. i have corsa axlebacks. i dont really want to buy a tune cause i dont have that much cash to kick around.

    let me know about your combos
    mustangmike6996, Jan 21, 2007
    #1

  2. bigcat start with the upper hole, and if more traction is

    Member Since:
    May 2, 2005
    Message Count:
    4,250
    Likes Received:
    2
    Trophy Points:
    78
    you can run the MIL eliminators without a problem, i did. check into Pypes X or H for an affordable piece. (both are under $200)
    bigcat, Jan 21, 2007
    #2

  3. 05xgt New Member

    Member Since:
    Jan 18, 2007
    Message Count:
    85
    Likes Received:
    0
    Trophy Points:
    0
    Pypes H pipe with a pair of Flowmaster 40 series will give you all the noise u want and then some.
    05xgt, Jan 22, 2007
    #3

  4. mustangmike6996 Member

    Member Since:
    Nov 11, 2005
    Message Count:
    401
    Likes Received:
    0
    Trophy Points:
    16
    well how does the h sound over the x cause i had a 96 gt with longtubes and a 2 1/2" x and it was a little raspy ... and the corsa's that i have on my 06 seem to be a tiny bit raspy at idle

    oh and how much for mil elims??
    mustangmike6996, Jan 22, 2007
    #4

  5. Hoboattacker New Member

    Member Since:
    Sep 7, 2005
    Message Count:
    550
    Likes Received:
    0
    Trophy Points:
    0
    I have FRPP Shorty Headers, Pypes Off-Road H pipe, and Pypes Violators axlebacks and it's awesome. It's a pretty throaty/gurgly sound at idle and even more so under slight load going through the gears. Floor it and it screams, very little if any rasp at all.
    Hoboattacker, Jan 22, 2007
    #5

  6. kooldawg6 mine works really well and can take a fair amount

    Member Since:
    Aug 31, 2006
    Message Count:
    1,718
    Likes Received:
    1
    Trophy Points:
    0
    That's why I just ordered the H this past Friday...but they won't be in stock until first week of Feb at Brenspeed...:drool:
    kooldawg6, Jan 22, 2007
    #6

  7. bigcat start with the upper hole, and if more traction is

    Member Since:
    May 2, 2005
    Message Count:
    4,250
    Likes Received:
    2
    Trophy Points:
    78
    if you buy the mils at the same time as the h pipe from brent, he usually adds $50 for the mils. if you buy them separate, i thnk they are over $60
    bigcat, Jan 22, 2007
    #7

  8. mustangmike6996 Member

    Member Since:
    Nov 11, 2005
    Message Count:
    401
    Likes Received:
    0
    Trophy Points:
    16
    not to sound like an a$$hole but what does the mpg drop/ raise . i have seen some peoples increase...
    mustangmike6996, Jan 23, 2007
    #8

  9. bigcat start with the upper hole, and if more traction is

    Member Since:
    May 2, 2005
    Message Count:
    4,250
    Likes Received:
    2
    Trophy Points:
    78
    i have not noticed a big difference. it is close enough that driving habits come into play more than anything. if i drive a little more hwy, it goes up. i dont think you could say either way for certain if it helped or hurt, but i dont believe it hurt my MPG at all.
    bigcat, Jan 23, 2007
    #9

Share This Page