My new project (90 GT) has damage to the lower radiator support like they ran over a parking curb. Basically it is just the lower portion pretty much centered. Now, I have a 89 GT vert as a donor and I was thinking of cutting out this portion and swapping it in there.
Opinions if I should go this route or leave it? Are there any issues with this or problems I am going to run into?
Should I order a team Z tubular lower support and swap it?
or??????????????
I don't think I would have issues with leaving it but I kinda want it to look right too...... I would appreciate any opinions anyone may have or anyone with experience or knowledge of working on this would be awesome. Just taking a quick peek at it, it looks like some areas are doubled up and not sure if this would cause issues.
Johnny
Opinions if I should go this route or leave it? Are there any issues with this or problems I am going to run into?
Should I order a team Z tubular lower support and swap it?
or??????????????
I don't think I would have issues with leaving it but I kinda want it to look right too...... I would appreciate any opinions anyone may have or anyone with experience or knowledge of working on this would be awesome. Just taking a quick peek at it, it looks like some areas are doubled up and not sure if this would cause issues.
Johnny