- Dec 25, 2012
- 240
- 16
- 29
Hi guys,
I am getting ready to begin my first engine build and have a few questions for you guys. Upon measuring the cylinder bores I found that most all of the cylinders were at about 4.024-.027. I am currently looking for 4.030 pistons to use once I get the engine bored to the new diameters. I will be using the stock connecting rods and standard stroke. I wanted to go with forged pistons and my top end that I can spend is right around $350. I was looking at either probe or dss pistons and was wondering if you guys had any experience with either of the brands. Please give me your feedback and opinions on both companies and your thoughts.
Thanks,
Andrew
I am getting ready to begin my first engine build and have a few questions for you guys. Upon measuring the cylinder bores I found that most all of the cylinders were at about 4.024-.027. I am currently looking for 4.030 pistons to use once I get the engine bored to the new diameters. I will be using the stock connecting rods and standard stroke. I wanted to go with forged pistons and my top end that I can spend is right around $350. I was looking at either probe or dss pistons and was wondering if you guys had any experience with either of the brands. Please give me your feedback and opinions on both companies and your thoughts.
Thanks,
Andrew