which wires with longtubes

Discussion in 'Fox 5.0 Mustang Tech' started by tvmango, Dec 10, 2003.


  1. tvmango

    tvmango New Member

    Joined:
    Oct 27, 2003
    Messages:
    667
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    bradenton florida
    I am installing twisted wedge heads with bbk longtubes, and problems with wires on this setup? I was going to get the taylor 409's with the 135 degree boots. Is that cool, or do you reccomend any other wires? Do you mount them under the headers or normal? thanks..
     
    #1
  2. 85_SS_302_Coupe

    85_SS_302_Coupe it sucks (I know) to be on the receiving end

    Joined:
    Nov 11, 2003
    Messages:
    282
    Likes Received:
    887
    Trophy Points:
    173
    Location:
    Northern KY
    i'm not sure about part numbers but whatever wire you get, i've seen guys use heat deflector tape on their wires to keep the headers from cookin'em
     
    #2
  3. matm347

    matm347 Founding Member

    Joined:
    Aug 29, 2000
    Messages:
    2,056
    Likes Received:
    0
    Trophy Points:
    0
    I run the Taylor pro race and some wire separators, I have no problems with them touching.
     
    #3
  4. sidewayzisbest

    sidewayzisbest New Member

    Joined:
    Feb 6, 2003
    Messages:
    430
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Lexington, SC
    i was thinkin bout wrapping 2-3 inches of header wrap around my wires do yall think that will work?
     
    #4
  5. matm347

    matm347 Founding Member

    Joined:
    Aug 29, 2000
    Messages:
    2,056
    Likes Received:
    0
    Trophy Points:
    0
    Better than nothing, just keep them off the headers.
     
    #5

Share This Page