347 Build With Mechanical Roller Camshaft

[General karthief]

Yes I agree on the torque. Love to see the dyno sheet. but there is something really wrong with only 20 degree of timing.

Is it possible the cam could be ground advanced? Did't go back to see specks and hard to belive cam was ground that far advanced, but??? I'm not an engine modification expert, more like a guy that just asks kinda dumb questions.

 

[HotFox]

It's possible, probably peak power at 4K or less if too far advanced. I doubt it though as intake valve to piston clearance would be a problem. Dyno sheet would tell a lot.

 

[CarMichael Angelo]

Again,.....even at 11:1 NOTHING with a 16 in the title.
http://www.vpracingfuels.com/vp-drag-racing

 

[TRQ]

I'll try to get the dyno sheet for more details on the run...
still wondering if this because the cam was never degreed!! just set at zero advance with the dots on the gears.

What of the VP fuel list, would be the best for my car combination?