Which oil pump and crank gears did you go with?
I think it will be alright, from what I hear it's when you start revving it higher than factory or high horsepower like 700 plus.what kind of power you putting down with yours now?I'm kicking myself now for not knowing about the gears before doing the install. I'm running a 3.8" pulley so it's not a lot of boost. Hopefully it holds till I order my next round of bolt ons. Hoping this year to order long tubes, smaller pulley, oil pump and gears, harmonic balancer, new clutch and flywheel.
Lund said I should be putting down low 600s so give or take 40 HP I'm guessing depending on dyno, temp, air quality, and the fact that I've got different wheels, tires, driveshaft, and axles... My Rev limiter was increased to a 7600 soft limit and then 8000 hard limit. With stock tires I was turning around 7500 at the end of the 1/4 so I went with a slightly taller tire to bring the revs down just a hair. Lund said when my 60's get better my trap may increase and I'm afraid if my trap gets any higher I'd have to get out of 4th gear. =(I think it will be alright, from what I hear it's when you start revving it higher than factory or high horsepower like 700 plus.what kind of power you putting down with yours now?
Awesome, what did you run in the quarter and what was your trap speed?Lund said I should be putting down low 600s so give or take 40 HP I'm guessing depending on dyno, temp, air quality, and the fact that I've got different wheels, tires, driveshaft, and axles... My Rev limiter was increased to a 7600 soft limit and then 8000 hard limit. With stock tires I was turning around 7500 at the end of the 1/4 so I went with a slightly taller tire to bring the revs down just a hair. Lund said when my 60's get better my trap may increase and I'm afraid if my trap gets any higher I'd have to get out of 4th gear. =(
I have a JT trim on mine which is comparable to the 2200. 11lbs of boost the car made 646 rwhp and went 10.98@131 first pass out (kick off for no roll bar)Awesome, what did you run in the quarter and what was your trap speed?
I'm running a 3.8" pulley I think that's only 8-9 lbs I might be closer to mid 500s then.I have a JT trim on mine which is comparable to the 2200. 11lbs of boost the car made 646 rwhp and went 10.98@131 first pass out (kick off for no roll bar)
That 125 mph or so tells me that it makes around 570 rwhp or so, another 3 lbs of boost is all that separates your from when I'm at currentlyI'm running a 3.8" pulley I think that's only 8-9 lbs I might be closer to mid 500s then.
No biggie man, I'm curious as to where I'll be, I have a 3.6 pulley to put on still@Kenneth sukosd Sorry for hijacking your thread man!
@Kenneth sukosd Sorry for hijacking your thread man!