ok, i got the kit in. i ordered the one from x2cmotorsports.com. removed the rear seat no problem, was gonna do the seat belts too but i had to goto work so i'll just do that another day. my question is on the bottom panel for the rear seat delete.
after removing the seat there was this frame that ran along the bottom with 2 bolts in the middle and one on each end. this is causing the center to push up at the very back of the rear seat delete panel. i was thinking about removing them, but have not checked to see if there is a nut on the bottom holding them on. anyone else have a problem with this?? know how to fix it??
beyond this the kit looks good. i will post pics when i get home and can transfer them to my computer. one thing that the kit mentioned was some velcro, but uhhh...there was none in my kit. it also came with 2 L shaped brackets but made no mention of them at all. basically, sit the bottom panel in, put the top panel in, and put the screws back through the holes in the top of the back panel. but if i were to do this by reusing the bolts like was suggested they won't fit, they are not long enough. plus they don't have anything to screw into on the back side. makes me wonder. who know's when i get some time here i'll goof around with it a little more and make it fit perfect.
another thing i found, was when i removed the seat there was this HUGE gash in the plastic panel to the drivers side. the mark was below the seat line and i know i didn't do it when i removed the seat. this thing is HUGE, and completely visable now with the kit in. i'm gonna have to buy a new panel, cause i know ford would say that i did it when i removed my seats.
after removing the seat there was this frame that ran along the bottom with 2 bolts in the middle and one on each end. this is causing the center to push up at the very back of the rear seat delete panel. i was thinking about removing them, but have not checked to see if there is a nut on the bottom holding them on. anyone else have a problem with this?? know how to fix it??
beyond this the kit looks good. i will post pics when i get home and can transfer them to my computer. one thing that the kit mentioned was some velcro, but uhhh...there was none in my kit. it also came with 2 L shaped brackets but made no mention of them at all. basically, sit the bottom panel in, put the top panel in, and put the screws back through the holes in the top of the back panel. but if i were to do this by reusing the bolts like was suggested they won't fit, they are not long enough. plus they don't have anything to screw into on the back side. makes me wonder. who know's when i get some time here i'll goof around with it a little more and make it fit perfect.
another thing i found, was when i removed the seat there was this HUGE gash in the plastic panel to the drivers side. the mark was below the seat line and i know i didn't do it when i removed the seat. this thing is HUGE, and completely visable now with the kit in. i'm gonna have to buy a new panel, cause i know ford would say that i did it when i removed my seats.