- Feb 17, 2011
- 73
- 0
- 7
lol
Made an idiotic mistake today... Went to jack up the rear end to swap wheels and thought i had the jack under the middle of my axle, however it was sitting on the edge of it and when weight was applied while being jacked up it slipped and bent a corner of my diff cover. It's not a whole lot maybe 1/2-3/4" in at the furthest point (it is on the corner). It's not leaking or anything and it's never seen so do you think it's worth replacing or trying to straighten or should i just not worry about it? I'll post pics of it tomorow.
Also on this topic, how come on the bottom two corners of the 8.8 there are like half circle cut outs?
Anyway thanks for your advice on my hasty mistake!
Made an idiotic mistake today... Went to jack up the rear end to swap wheels and thought i had the jack under the middle of my axle, however it was sitting on the edge of it and when weight was applied while being jacked up it slipped and bent a corner of my diff cover. It's not a whole lot maybe 1/2-3/4" in at the furthest point (it is on the corner). It's not leaking or anything and it's never seen so do you think it's worth replacing or trying to straighten or should i just not worry about it? I'll post pics of it tomorow.
Also on this topic, how come on the bottom two corners of the 8.8 there are like half circle cut outs?
Anyway thanks for your advice on my hasty mistake!