I'm finally ready to swap the transmission. This automatic is just killing the full potential of my car. If i go to the 5 speed i will get 30% more of the hp in my engine to the rear wheels.
Going to go with the Tremec 3650. Are re manufactured tranny's a bad idea?
From what i have gathered i will need, Clutch, Cables, Flywheel, (Install guy is nearly demanding aluminum for some reason) Different yoke for driveshaft, Crossmember, Pedals, Shifter, re tune the computer, and a lot of money.
Do you know of any conversion kits offered?
May i get your opinions or advice on this, Have any of you done this or know someone that has?
Appreciate your time. This project is something i've been wanting to do for years.
Thank You very much
Regards,
Alexander
Going to go with the Tremec 3650. Are re manufactured tranny's a bad idea?
From what i have gathered i will need, Clutch, Cables, Flywheel, (Install guy is nearly demanding aluminum for some reason) Different yoke for driveshaft, Crossmember, Pedals, Shifter, re tune the computer, and a lot of money.
Do you know of any conversion kits offered?
May i get your opinions or advice on this, Have any of you done this or know someone that has?
Appreciate your time. This project is something i've been wanting to do for years.
Thank You very much
Regards,
Alexander