Yeah that looks just about the same place I have room but i think I can inch them forward a bit more. Does the Bassani pipe assemble with band clamps? Any idea what the substrate in the cats is made of?Best pic I have at the moment. I’ll try to remember to get one from the side. But the cats are after the X-memver. I’ll take a better shot later
Yeah that looks just about the same place I have room but i think I can inch them forward a bit more. Does the Bassani pipe assemble with band clamps? Any idea what the substrate in the cats is made of?
I’ll be a little forward of this, totally flush with the tail housing.
Wow, $900 for the Bassani catted X-pipe! I had to look mine up. I paid $667 for mine three years ago.Thanks for the pictures.
I just ordered 2 of the Magnaflow 53956 and stainless steel band clamps. The Basssni piece is nice but that would cost me $900. I can get what I need done for $267 by splicing in to my existing pipe. And I would not need all the air tubes that come as part of the Basssni anyway.
I started to buy parts for my car a couple of years ago " predicting " what was going to happen... Boy was I right.. Shocking is the best I can describe how much items have gone up.....Wow, $900 for the Bassani catted X-pipe! I had to look mine up. I paid $667 for mine three years ago.
Bill
How about this idea? Since the cats will be further back, maybe put a heat shield to retain heat. Do you think this can help the cat function more efficiently in cleaning the exhaust? I know the product is intended to keep the floor board cooler and that's good too. But will it also help the function of cleaning exhaust.