Hi,
So Im going to buy the following for $1400 this weekend - its used, from a local forum:
Tremec 3550 w/ 26 spline input
Bell housing
Centerforce dual friction clutch, press. plate and flywheel
Tri-ax shifter
Aluminum driveshaft.
I drove the car it was in today before I bought it to make sure it was all in good order and seemed to be fine.
With the 26 spline input shaft, what will this trans hold? Stock rating is 425 lb ft, but I couldn't find anything else to gauge what it will hold.
Since Im expecting 475-500 lb ft from my 408, should I upgrade the tailshaft too so it would be like a TKO?
Thanks,
Collin
So Im going to buy the following for $1400 this weekend - its used, from a local forum:
Tremec 3550 w/ 26 spline input
Bell housing
Centerforce dual friction clutch, press. plate and flywheel
Tri-ax shifter
Aluminum driveshaft.
I drove the car it was in today before I bought it to make sure it was all in good order and seemed to be fine.
With the 26 spline input shaft, what will this trans hold? Stock rating is 425 lb ft, but I couldn't find anything else to gauge what it will hold.
Since Im expecting 475-500 lb ft from my 408, should I upgrade the tailshaft too so it would be like a TKO?
Thanks,
Collin