Hey guys, I recently tried installing my 3 peice mach 1 grill delete kit. Everything was going fine intalled rear piece no problem, then when I bolted down the front fascia piece thru the original holes in the bumper everything still was pretty good. I then went to put the push pins in the top corners that connect the trim piece to the bumper and the passengers side worked and looks great, but the drivers side was way off and when I shoved it over and got it to line up and put the push pin back in, now there is a freaking huge 1/2" wide gap on the drivers side between the trim piece and the front bumper. What's the deal? Supposed to be oe piece which has the studs on the bottom that line up and go thru factory holes in bumper but appears as if the panel is like 1/2" too narrow? Any one else with this problem?
Thanks,
P.S. Also the pony that came in the kit is very crooked and the horse runs down hill when installed on the car...very upset about this as well, but ordered a new horse from american muscle and hope it will be better than the one I got elsewhere...
Thanks,
P.S. Also the pony that came in the kit is very crooked and the horse runs down hill when installed on the car...very upset about this as well, but ordered a new horse from american muscle and hope it will be better than the one I got elsewhere...