I ran the codes again and i got the following:
KOEO
564-Electro-Drive Fan circuit failure
Memory:
113-ACT Sensor Circuit Above Maximum Voltage of 4.6 volts (O), ACT circuit has intermittently failed above the maximum of 4.6 volts (M)
118-ECT Sensor Circuit Above Maximum Voltage of 4.6 volts (O), ECT sensor circuit has intermittently failed above the maximum of 4.6 volts (M)
122-TPS circuit below minimum 0.6 volts (O), TPS circuit has intermittently failed below minimum 0.6 volts (M)
157-MAF sensor went below 0.4 volts during the last 80 warm-up cycles
158-MAF sensor went above 4.5 volts during the last 80 warm-up cycles
Also when i put the key on engine off and put the jumper wire in, the fan kicked on for a couple seconds then shut off. Not sure if that means anything or if thats how its supposed to be.
I also looked at the connectors to the MAF & the Air temp sensor and i dont see any open wires, or loose plugs.
I havent yet cleaned the MAF i need to find the TORX bit, i have them somewhere i dont wanna go buy something i already have.