Search results

  1. Bearded Forever

    2019 Bullitt Dyno Run

    Here is my Bullitt's pull on a Mustang Dyno, no modifications. We hit the speed limiter in 4th gear at 6700rpm. View: https://www.youtube.com/watch?v=aZ1ZaWOEu8I
  2. Bearded Forever

    So yeah...

    Finally got settled in after the move home. Replaced the turbo center section and no smoke! Well then she starts the next day. She'll only smoke if I boost high and she pops. I believe boost is getting past the rings and causing the cylinder/s to misfire and then push oil into the chambers. So...
  3. Bearded Forever

    Help me Boost again!

    I need a .60/.63 Turbocoupe T3 Turbo, water cooled, and with a compressor housing for non intercooled cars. I do not want anything that needs a rebuild anytime soon. My current turbo has shaft play and the front oil seal is leaking. I can trade my current turbo as a core, if you'd like, to...
  4. Bearded Forever

    **Wanted**

    My current block has worn rings and smokes. It would be easier for me to just buy a short block that doesn't need any work done anytime in the near future. I'm looking for a short block with low miles (around or lower than 80k) and as close to stock as possible (Ready to install). Preferably...
  5. Bearded Forever

    Ummmmmmmmmmmm...

    See you mofos in January.
  6. Bearded Forever

    I have heat again.

    I went slow ans easy. Ended up with 3 extra screws and a sore back and hands. Now I can continue to be the victim of Miata fly bys in sub *40 weather and be comfortable.
  7. Bearded Forever

    Anyone have $9.99?

    Free shipping if you buy 3! http://www.target.com/gp/detail.html/sr=8-2/qid=1101765053/ref=sr_8_2/601-2447507-7292105?_encoding=UTF8&asin=B000005D70
  8. Bearded Forever

    Shes dead...

    I got on the highway and noticed the turbo was louder than normal. She spooled really quick, almost instantly, and then I get off the highway. It idles at 1500 all the home then it settles down. I take it apart thinking it was the gasket between the intakes, nope. I can't find any leaks...
  9. Bearded Forever

    I'll be gone 'till November...

    Flying home for Thanksgiving so you busters won't have any house entertainment. Well maybe the Kansas Krew can halp you out there. Which brings me to my question of the month.
  10. Bearded Forever

    Slide to the left, slide to the right!

    If the diaphram in my adjustable fuel pressure regulator was bad and was leaking what would my a/f gauge show at cruising speeds? I'm brainstorming before I go check my vam and afpr in the morning pending dry weather.
  11. Bearded Forever

    Congratulation, it's a 2.3T!

    I have my timing at *10, I fixed the TPS and I still pop and stutter accellerating at WOT in 3rd with an LB3 around 5000rpm. I think it's the timing so I'll turn it down again. My question is after it stumbled I let off and went easy, then 5 mintues later I accelerated hard in 3rd up a hill and...
  12. Bearded Forever

    TPS set at 1.23?

    I finally got a reading and I set it .96v. Would that 1.23 be the cause of my highway speed stutter or my accel up a hill stutter?
  13. Bearded Forever

    Popping at cold idle?

    I guess it's a miss I'm having, it sounds like small amounts of muffled air popping. Everytime it happens my rpm needle jumps up 300rpm but the engine doesn't rev any higher. You can tell when it revs higher from the higher tone but this is just a needle jump with the pop. What gives?
  14. Bearded Forever

    TEE PEE ESS

    What's the easiest way to repalce it? Just scribe some marks around the old TPS and slap the new one on?
  15. Bearded Forever

    Warning Chime

    Over the summer I noticed, after turning my stereo down once, that the seatbelt chime wouldn't stop. Anytime the key was in and the car was on, it was on. I just pulled the box with the speaker deal in it and pulled it off. Will this thing still draw current? What would cause this? None of my...
  16. Bearded Forever

    ???

    If there are only 4 spark plugs for my car whay are there 5 wires? Is there a spark plug in the distributor?
  17. Bearded Forever

    Manual Fan Switch

    Which wire do you use, the power or the ground for the switch?
  18. Bearded Forever

    Finally got some new headlights!

    6 pc clear corners too. Damn I can see the highway! Before and after pics. Before Ugliness After Hotness
  19. Bearded Forever

    Low level oil sender

    I need to know how this goes on. Does it just screw in or does the nut squeeze it together like a compression fitting? I'm getting small oil seepage from the sender itself but it runs over the nut. I'm wanting to just put JB Weld around the sender inside the nut. :notnice: