Search results

  1. 1

    Walked an 06GT... Man I feel good!!

    Last night I raced an 06 GT from a stop. He pulled up next to me when I was at a light. He rolled his window down and yelled something to me. I looked over to see a guy with his girl to the right of me. I rolled my passenger side window to hear him complimenting my car. He said it sounded...
  2. 1

    Possible oil pressure problem, need opinions

    I have an autometer phantom electrical oil gauge and recently my pressure has been dropping very quickly when I get on it. The pressure always reads fine when at idle or normal driving, but at WOT when it reaches 3K, I notice the needle suddenly slam down to almost 0, then jerk around and...
  3. 1

    About to order PA 3G alt. kit, have some questions

    I'm about to order an alternator kit from PA performance. Which power wire should I get; standard short, standard long, premium short, or premium long?
  4. 1

    Need advice on Autometer tachometers

    So I was driving today and my stock tach suddenly stopped working. The needle is now stuck at the 1,500rpm mark and won't budge. I installed some white faced gauges a couple weeks ago, and had to remove the needles, so I think that might have something to do with it. Anyhow, since the stock...
  5. 1

    Moroso cold air intake vs. stock air box w/K&N

    I'm thinking about buying a Moroso cold air intake kit from Summit for $91.88. Will I notice an increase in power over the stock air box with a K&N? Is the moroso worth the $$?
  6. 1

    Best wires to get???

    I'm going to be doing a tune up on my stang next week and was wondering which would be the best wires to get. Right now I have FMS 9mm, but am looking into getting better wires. My mods are: Edelbrock performer heads/performer intake, e-cam, and all the usual bolt-ons. The wires will be run...
  7. 1

    white faced gauge install

    i'm about to install a set of white faced gauges i bought from blue oval industries. the directions that came with them are not for 87-93, but for 99+ years. does anyone have a link to a site that has directions on how to install on an 87-93? thanks.
  8. 1

    Blue Oval Industries is REALLY making me angry. Need advice

    On 3/31 I placed an order online with blue oval industries of VA. I purchased a set of white face gauges and a clutch quadrant. My order was processed, I received a confirmation email, and my credit card was charged the $105 total cost on 4/3. It is now 4/13 and I still have not received my...
  9. 1

    Installing a new dizzy

    I'm about to order an MSD bullet distributor and have a question about the install. I know how to install it, but would it be okay just to mark the position of the stocker, yank it, then stab in the new one and line it up to the mark of the stocker? Or do I have to do all the bs like pulling...
  10. 1

    Which distributor?

    I want to get all the supporting mods first before I get a blower next summer, so I want to upgrade my ignition. I'm getting an MSD 6AL box with rev limiter, blaster coil, and a new distributor. Which is better distributor, Accel or MSD?
  11. 1

    Why does my car buck below 3000rpms?

    If I put it to the floor in any gear except 1st below 3000rpms my car will buck a bit before the rpms start to climb. My car runs perfectly fine and pulls hard, but for reason it has always bucked a bit, especially after my H/I/C swap last winter. Could it be bad motor mounts? What would cause...
  12. 1

    Will my 255lph pump be enough?

    Right now I have a Walbro 255lph inline fuel pump and its fine for my current setup which is a stock block with Edelbrock heads, performer intake, and an e-cam. However I am getting a Novi1000 in the near future and will be running 5-6psi or boost. Will my 255 be good enough or will I need to...
  13. 1

    Solid or poly motor mounts?

    Which would be better from a street car? Solid or polyurthane motor mounts? Which are better in general?
  14. 1

    Will energy suspension poly motor mounts work with a vert?

    I want to replace my stock 16 year old motor mounts with a set of energy suspenion poly mounts. I know that hard tops and verts had difference mounts from the factory, and was wondering if the energy suspension mounts are only for hard tops because it does not state whether they are or not...
  15. 1

    Gas gauge doesn't work. What could it be?

    My gas gauge recently stopped working. It always reads on full now when the car is actually low on gas. Is there a sending unit that could cause this? If so where is it located? The tank?
  16. 1

    Thinking of swapping out spec stg 3 for Centerforce DF... Need advice

    I've had a spec stg 3 clutch with aluminum flywheel in my car for almost two months now. I like the clutch and all. It grabs real hard and can take a ton of abuse, but I just feel it isn't a good clutch for me because my car is pretty much my daily driver. It is often difficult to start off...
  17. 1

    Aftermarket ignition worth it on a 302?

    From what I've heard, the stock ignition is not all that bad. Right now I have mild h/i/c setup with completely stock ignition and all seems well. However, I'm looking into getting a Novi1000 in the future and am curious as to whether the stock ignition will cut it or not. Which is the...
  18. 1

    Question about shifting characteristics of my TKO500

    Ok my TKO is fully broken in now (been like 700 miles). I changed the fluid at 500 miles. When driving around normally it shifts just fine. Goes into every gear nice and smooth, etc. It almost feels like my old T-5. However when I get on it and shift fast it is rather tough to get into...
  19. 1

    Which motor mounts?

    One of my motor mounts is cracked and in need of replacement, so I figure I might as well replace both while I'm at it. Which are the best motor mounts and where can I buy them? I want something better than stock... Also, how difficult is it to swap motor mounts? Is it something I can do...
  20. 1

    sc-trim or novi1000?

    Which would be better for a spring/summer daily driven street car? Which would be more quiet? Which would produce more power? WHICH IS THE BETTER BLOWER FOR THE $$?
Top Bottom
Back
Forums
Menu