Search results

  1. ram360

    Low Idle, Stumbling When Driving

    So my 94 cobra developed weird issues last week. Cold start the car will fire right up and idle normal 800 rpm or so for about a minute then my idle drops to 550rpm. It's a mild H/C/I, tfs stage 1 cam. and it's just barely running at that rpm. I did the idle reset etc.. and no matter how much...
  2. ram360

    Electrical Gauge Wiring Schematic Needed

    I alright guys I'm wiring up some gauges in my 94 GT. I need to find the dimmer wire to tap into. Anyone have some wiring schematics for a 94GT headlight switch. I can find every other one but the schematic for that. I'm having a hard time finding what I need tap into for the dimmer wire. Anyone...
  3. ram360

    ? For anyone that knows aftermarket alarms

    For the life of me I cannot figure this out. I wired my entire alarm in over the winter works great w/ the exception of the trunk trigger wire. Instructions tell me I need a neg trigger. The only thing I can find on the car for a trunk trigger is the black/pink wire...I looked at some diagrams...
  4. ram360

    94 Gt Wiper Control Module Location

    Anyone know where it is? I'm sure it's on the drivers side under the dash but where? Near the fuse box?
  5. ram360

    Wiring Help! Windshield Wiper Related

    The wipers on my car stopped working all together. I though it was the fuse.... Checked that (I think it's in position 4 in the kick panel fuse box 30a), and it was not blown. Thought it was the multifunction switch. Replaced it w/ a spare I had lying around and again nothing. I don't think...
  6. ram360

    Help finding this wire

    I'm hooking up a car alarm to my 94gt. I need to find the wire that is for the trunk pin-(the pin goes to ground when the trunk is open) so it's a negative trigger for my alarm. Anybody know what the color is? I don't even know if I have a trunk pin, I don't have a trunk light? I found the...
  7. ram360

    94 GT Wiring Help Needed

    I was having problems w/ only one of my door locks opening w/ the key fob, none would lock and interior door lock switches did nothing at all. I found an old alarm system on the car and I don't have the remote for it. It did control door lock functions etc... at one point w/ the units...
  8. ram360

    11-9-2008 PennMustangs Fall GTG (Bloomsburg PA)

    PennMustangs Fall GTG Date: November 9, 2008 Time: 12:00pm - ? Location: Quaker Steak & Lube 211 Columbia Mall Drive Bloomsburg, PA 17815 (570) 389-WING (9464) ::: Quaker Steak & Lube ::: Fall get together at Quaker steak & lube in Bloomsburg PA 11-09-08 PennMustangs Fall...
  9. ram360

    NEPAer's Scranton PA Quaker Steak and Lube Grand Opening

    10-15-2008 Dickson City Quaker Steak and Lube Grand Opening - PennMustangs there will be a group of us there at 5pm Oct 15, 2008....I'll have my teal 94gt there along w/ a few other mustangs. Just giving the heads up if anyone might be interested.
  10. ram360

    Down on power, hesitating, here we go again...

    So the car was driving awesome today. Left to go home, and and half want into the trip I notice the car is down on power, hesitating, poor throttle repsonse, cutting out etc....I had to keep in the gas pretty good to keep it running long enough to get home (ran marginally better in a little...
  11. ram360

    Headlight switch problems (94gt)

    So my headlight switch went bad. basically my headlights come on but my dash and taillights don't w/o me finding the sweet spot on the switch to make everything come on as it should. Sooooo I pull the switch out today and notice the plastic connector that plugs into the headlight switch is...
  12. ram360

    Door Lock Issues Please Diagnose

    I have been having some issues w/ the door locks (94gt). Basically they both lock/unlock w/ the key just fine. Only the drivers side opens w/ the key fob. None of the doors lock w/ the key fob and the door lock switch inside the car will not lock or unlock the doors at all. I can hear a...
  13. ram360

    4rw70 trans massive fluid leak

    So I'm driving and decide to get on it a little from a 30mph roll. Car is 94 gt w/ 4rw70 trans (shift kit, atco clutches, 3200 stall) . car shifted fine, no noises, anything unusual. Trans was totally build less than 12k agao. I look in my rearview and see this huge clowd of white smoke...
  14. ram360

    Auto Stalls when put into Drive or Reverse

    Trying to figure this out as it has become very annoying. Trans is a 4r70w 94gt. Car idles fine put when I go to put it in D or R the car usually stalls. I usually have to give the car gas an almost drive it like a stick car just to get it moving w/o stalling it out. Tried cleaning the IAC w/...
  15. ram360

    Considered joining the SN95 Ranks...Good deal?

    Ok so I'm selling my bike 2004 zx-10r (crotch rocket) Now I had someone offer me a trade for a 95 gt. 302 H/C/I car Custom paint, obviously taken care of. N/A 316/340 rwhp/tq on the dyno, gears, igniton, etc... Only bad this is that it's converted to carb. I bought my bike brand new in 04 for...
  16. ram360

    Wiring Guru's Fuel Pump Problem

    I'll start by saying I just put in a replacement starter solenoid. I did however go over the wires and they are indeed in the correct spot and I checked my grounds. Keep in mind the car worked fine prior to this. The car does crank but my fuel pump is not priming. I can hear the eec realy click...
  17. ram360

    Stangnet cars.....Pics

    a few of us got together for a small cruise... will post up some more pics but I'm having trouble uploading.......be patient.
  18. ram360

    First Ever Video Of My Car Actually Moving

    I just did it for the exaust clips...No, I wasn't into it at all, under very minimal throttle. Shifted out of 1st at maybe 4K. Flyby was at maybe 80 or 85mph... I posted the video on streetfire yesterday and everyone is like it doesn't seem that fast. But how fast is an 80mph flyby supposed to...
  19. ram360

    Scratches in Glass

    Is there any way to remove scratchs from door glass, windshields. They are light scratch that have occured over the years so I was wondering if there are compounds or something I can do to remove them. Just exploring some options other than new glass. Ideas?