89 blue lx
Founding Member
94GTLaserRC said:So when you had the 275's, they were ok?
Mine are new, so wont change for awhile..May go with 285's next time and some 1" spacers.
Thanks
RC
95-5.0 said:Sweet! 17x10 99 cobra wheels would look great.
.Coltzilla said:It was $350 for both rear wheels. Check out www.weldcraft.net. It took about 3 weeks. Car looks stock from the side, but from the rear it's a different story.
Coltzilla said:It was $350 for both rear wheels. Check out www.weldcraft.net. It took about 3 weeks. Car looks stock from the side, but from the rear it's a different story.
Coltzilla said:I am running a 1" spacer from Maximum Motorsports. I did not have to flip the quad shock. I did have to adjust the right side tail pipe for clearance. No rubbing at all. As far as the balance goes, Weldcraft widens the wheels on a wheel lathe. There was and is no problem with the balancing. I hope that answers all your questions. I am happy with the results
Bishop said:My setup is this:
........
Coltzilla said:Sent my 96 Cobra wheels to Weldcraft to have 2 inches in width added. Then I put a little 315/35 Nitto drag radial under there. Let me know what you all think.