Hello again, I'm going to make my own custom side exhaust for my 95 gt. I'm going to cut and fit various mandrel bends and clamp it all in place where it needs to be. Afterwards I'll take it and have someone weld all the seams up for me so I don't have a bunch of leaks. I have a set of old 2 chamber mac mufflers and 4 brand new magnaflow cats that are 4" thick. My car is lowered about 1-1/4" and even with the 351w in it appears I have plenty room to fit the cats and muffler under the middle of the car where the stock h-pipe was. I'll use a system of u-bolt clamps and exhaust hangers to pull everything up against the car as close as possible without touching the car.
Now to do all that I calculate I'll need a total of 390 degrees worth of mandrel bends to make this happen. I'll need to 90 off the header and then turn 120deg. to the 4 cats. Then there'll be a 45deg turn into a x pipe with another 45deg out of it. Then there'll be a final 90deg turn after the muffler straight to some pypes evt19 tips.
Does 390 degrees worth of mandrel bending sound too restrictive? Thanks for any help I know this might sound a little crazy but from what I can see I can make it work.
Now to do all that I calculate I'll need a total of 390 degrees worth of mandrel bends to make this happen. I'll need to 90 off the header and then turn 120deg. to the 4 cats. Then there'll be a 45deg turn into a x pipe with another 45deg out of it. Then there'll be a final 90deg turn after the muffler straight to some pypes evt19 tips.
Does 390 degrees worth of mandrel bending sound too restrictive? Thanks for any help I know this might sound a little crazy but from what I can see I can make it work.