Kenne Bell 2.1 plus tons of parts!!!

Discussion in 'Engine and Power Adder Parts' started by 800phelps, Jan 30, 2010.


  1. 800phelps

    800phelps New Member

    Joined:
    Jan 4, 2010
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    I have a complete kit for a 99-04 mustang GT . kenne bell 2.1
    unknown mileage on the kit, because i purchased it used. i recently sent it in to KB to have it looked over and they found that the coupler was bad. i had them go through it and replace anything worn, so basically it's a 4k mile blower. everything works great as far as the kit goes.

    included in the kit is
    9lb pulley
    14lb pulley
    pulley removal tool
    big air kit
    75mm TB
    90mm maf
    42lb injectors
    KB BAP
    2 belts
    complete cooling parts. res, pump, H/E etc.
    coated idler pulleys (not the original that rust)
    sct 7 position chip (with a 91 and 100 octane tune.

    car made 393/420 on the 9lb pulley
    and 455/520 on the 14lb pulley

    3,800 plus shipping, but motivated seller
  2. 800phelps

    800phelps New Member

    Joined:
    Jan 4, 2010
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
  3. 800phelps

    800phelps New Member

    Joined:
    Jan 4, 2010
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    need this gone!
  4. XxMustang281xX

    XxMustang281xX Member

    Joined:
    Jun 10, 2004
    Messages:
    236
    Likes Received:
    0
    Trophy Points:
    17
  5. 800phelps

    800phelps New Member

    Joined:
    Jan 4, 2010
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    i have a guy that's supose to pick up the blower and shortblock sunday. had he not sent a deposit i would be interested.
  6. 800phelps

    800phelps New Member

    Joined:
    Jan 4, 2010
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    everything is SOLD!

Share This Page