- Feb 4, 2004
- 516
- 0
- 16
These arms are for a '67-'68 car but the same work can be done to a '65-'66 arm. The parts, a free aftermarket replacement arm, spherical bearing, sleeve with locking ring, spacers to fit the bearing to the car and the brace.
A close up shot of the parts and the finished piece.
Before and after the brace.
I used a hole saw to prep. the arm for the sleeve. The brace is made from 14ga metal. Total cost is $47.95, $29.95 for the bearing, $6ea for the spacers, $5 for the sleeve and brace. Much better than paying $300+ for aftermarket arms. It's not hard work and it didn't take long. Any comments are welcome and as always I will be glad to help if someone wants to make some.
John
A close up shot of the parts and the finished piece.
Before and after the brace.
I used a hole saw to prep. the arm for the sleeve. The brace is made from 14ga metal. Total cost is $47.95, $29.95 for the bearing, $6ea for the spacers, $5 for the sleeve and brace. Much better than paying $300+ for aftermarket arms. It's not hard work and it didn't take long. Any comments are welcome and as always I will be glad to help if someone wants to make some.
John