new motor numbers!!!!

[payupsucka]

here is a rundown of the mods


forged 306 bottom end

tfs tw heads
16 rr
e 303 cam
cobra intake
bbk 70mm tbody
c&l 73 mm maf
24# injectors
mac equal length 1 5/8 headers
bassanin hi flo cat pipe
mac cat back
280 hp 318 lb/ft tq

now the other mods to the car baer 5 lug brake kit with 13 fronts cross drilled and slotted 11.65 rears
3 73 gears centerforce clutch frpp c springs rear upr upper and lower rear control arms
upr tubular front k member coil over conversion and caster camber plates

ac and smog pump bypassed.

thats a rundown of the car i know i could have made more power with a better intake thats comming soon looking for 300 rwhp or bust :SNSign:

 

[Aliate X]

I would have put a TFS1 in there, the intake should put you past 300rwhp. Good luck! Spray that bitch lol

 

[payupsucka]

I would have put a TFS1 in there, the intake should put you past 300rwhp. Good luck! Spray that bitch lol

just ordered my zex 175 shot kit today dude iam right there with ya:SNSign:

 

[Aliate X]

just ordered my zex 175 shot kit today dude iam right there with ya:SNSign:

haha sweet, Im ordering my NX gemini kit next month, so looks like we are in the same boat.

 

[payupsucka]

wanna run em

 

[retro50]

Nice #'s. Have fun with it! With some traction 12's will come easy on the motor. 11's with the juice.

 

[Marlboro_Man]

Auto or 5spd?

What kind of compression ratio?

 

[Grn92LX]

How much timing? How was the a/f? Timing should be around 18* initial, if not thats one reason for the low numbers.

 

[payupsucka]

How much timing? How was the a/f? Timing should be around 18* initial, if not thats one reason for the low numbers.

low #'s ? i thought that i made decent power for a 306 with and e cam and a cobra intake. i dont remember the a/f ratio but it was pretty much perfect by the last run and that was the 280 hp run. no mind you the car was already getting hot and it was about 88 * out that day. timing is set at 17* cr is 10 to 1 i cant remember what the fuel pressure is at but i will get my print out and show it to you guys on weds