Which K-Member???

[stealthracing]

Hey guys, i'm going to finally put in a tubular k-member and a-arms, i was wondering which brands you guys have used or have experience with. I found a QA1 kit for what seems to be a good price, it includes the k-member, a arms, coil-overs, struts and caster/camber paltes for i think around 1100 or so. is this a deal or not?

 

[ImportEater98]

I am using the QA1 tubular k member with stock control arms. You have to do some modding to get the stock control arms to fit right. I'm sure its not the case if you buy QA1's a-arms. Overall very happy with the fit and finish. IMO i think the tubular a-arms are a waste of money. You might save 3lbs overall, but i can think of better ways to spend $250

 

[5.0 HOtrain]

I have the D&D

Been in the car for over 3 years with no problems. Two different motor/header combos too
mike.

 

[04sleeper]

I have the UPR kit with coil overs and CC plates. Works good so far. The only thing I don't like about it is no spring isolators and I am running 12 " springs. I think 14" would be better.

 

[Vipersix]

Maximum Motorsports has THE best setup as far as I'm concerned. A little on the pricey side but if you're going to use it, it's worth it. Street setup, go with QA1 or UPR. Street/Strip go with D&D.