I’ve browsed around a bunch haven’t seen much on this, started doing a wire tuck on the headlight harness (drivers side) noticed an oval plug hole on the drivers firewall inside the fender well (fenders off) Haven’t seen anyone utilizing this, anyone know why? I’ve seen people cut holes in the back of the tower and cut wires and pull them through the small hole near the brake booster. My thought was to expand the oval grommet in the fender well a bit, pull the harness back into the vehicle, then feed it through the hole I expanded. (I’ll obviously make it water tight after) Might help to add that my car is completely disassembled (doors,fenders,fender wells, hood, interior, bumpers, motor, tranny......the whole nine) thanks for reading, Thoughts? The picture I added is of the hole I’m referring too, red ring around it.