Wanna talk about pissed off ?! It was supposed to good day. I was going to the dyno, right ? I was pissed off after the first pulls on the motor as it was. I was only getting 275 to the rear. The ft/lbs were nice numbers though. 369 at like 4800. The motor should have more, but I didn't want to be there anymore. I was quite pissed that I rented the dyno for the day and the people wouldn't let me tune the bloody thing the way I wanted. So I was just going to get some numbers and tune at the track. I had had enough of them. Then the starter went out. Good 'ol Autozone products. Lifetime guarantee does no good if all you have is a guaranteed piece of ****! Once I got it in I ran the bottle. It was like 8/1 on the a/f ratio. After fooling with everything and running it again it was at a better but fat 11/1. That was the last run. At about 6300 I felt a bad vibration. I let off. Too late!! I twisted the driveshaft into almost 3 pieces. Into two atleast. It looked like a twisted straw that had been cut in the middle. It got real bad when I saw the starter I just put, in on the ground. When the driveshaft hit the ground it toook out my exhuast, tailshaft,bellhousing,and at least one arp stud on my stall. I don't really even know yet. I haven't looked. I already want to sell the thing I'm so FN pissed, looking at it won't help. I only know what I know from the parts that were on the ground under the car. It did make 341hp and472trq to the rear on a 100hp shot though. The 175 was next. Guess I'll never know. The 8 in held up