Full length subs on 96-98 Cobra?

[JETSOLVER]

Has anybody gone through the modification process to install full lenght weld-ons on the SN95 Cobra's? Mine are Steeda and conflict badly with the tranny crossmember. Thanks.

 

[97poonstang]

steeda's on my 97 cobra....no trouble

 

[JETSOLVER]

Are you sure that the ones you installed are full length ones? Most manufacturers call out these cars as different because of this problem. It looks as if I will either have to cut a good bit of the crossmember itself or cut slots in the subs and weld them to the X-member.

 

[COBRA90GT]

FWIW, Maximum Motorsports provides a set of instructions (see the "cobra supplemental" set of instructions within the following PDF document):

http://www.maximummotorsports.com/instructions/MMFL-3r1.pdf

MM's SFC page:

http://www.maximummotorsports.com/sfc.asp

 

[JETSOLVER]

Thank you! I was in a quandry as to whether the stamped steel would accept the notch. I am yet again in awe at the way this resource can make even a scarey project a weekend job.

 

[TruthSeeker]

I have Kenny Brown Super Sub frames. They were on the car when I bought it along with most of the other mods on my vert. I would think as long as they are full length and welded in then they should work great!

 

[03veloce]

check this out
http://forums.stangnet.com/showthread.php?t=473347

and there is a group buy going on over at SVT Performance