So i bought a Foxbody last week with a Loads of modifications but nothing seems to be well set.
Basically this is what is done to it
302
Heads Eldelbrock rpm valve 2.02'' 190cc with springs pushing rods solid lifter eldelbrock
cams eldelbrock 7122
Carb holly 600cc
intake eldelbrock
kit msd hvc with coil and rev limiter
headers longtube bbc with flowmaster 2.5"
distributeur summit racing
intake air gap
With 275 nitto 555r
brand new rebuild 5 speed tranny
Basically what i am looking for is either a correct setup were i can run 12 seconds or with the mods would it be better to upgrade the block
let me know
ran only high 13s.
Basically this is what is done to it
302
Heads Eldelbrock rpm valve 2.02'' 190cc with springs pushing rods solid lifter eldelbrock
cams eldelbrock 7122
Carb holly 600cc
intake eldelbrock
kit msd hvc with coil and rev limiter
headers longtube bbc with flowmaster 2.5"
distributeur summit racing
intake air gap
With 275 nitto 555r
brand new rebuild 5 speed tranny
Basically what i am looking for is either a correct setup were i can run 12 seconds or with the mods would it be better to upgrade the block
let me know
ran only high 13s.