Three of us tried for over 30 minutes to fit the Billet Pedals on. Hacked one all up and still no luck. We followed the instructions provided.
ANY OTHER HELPFUL HINTS ON THIS?
RC
ANY OTHER HELPFUL HINTS ON THIS?
RC
HELP WANTED: BILLET PEDALS!
- Thread starter 94GTLaserRC
- Start date
-
Sponsors (?)
Posted via Mobile Device
i used a hair dryer,soapy water,and a small,curved pick.
warm the pedal with the dryer til flexable,lube with soapy water,slide one side of cover onto pedal,then use the pick to gently pull the other side on.
good luck.
i used a hair dryer,soapy water,and a small,curved pick.
warm the pedal with the dryer til flexable,lube with soapy water,slide one side of cover onto pedal,then use the pick to gently pull the other side on.
good luck.
took me 15 mins
boiled em in some water and they went on easy
I thought about that, but I was waiting to see if someone had done this with success...didnt want to ruin them. I guess I can try that next time I get out there.
Thanks
RC
Chads95GT
Member
i boiled some water too. and then put the pedals in the water for a little bit to warm the rubber. but its still a PITA job. good luck with your install.
chad
chad
make sure u wear some gloves too! they get hot!
you can slip one side on and then try mashing the pedal down with your foot to get the other side in place (after boiling)
Chads95GT
Member
what turbo gt said. PATIENCE! but as a tool. i used a small flat screw driver. but like he said, start in the top left corner and work your war around clockwise.
i spent a hour putting mine didnt boil them cuz i hadnt heard any succes stories when i was putting them on i flared out the left and right side at the top slide it down on the pedal and used a samll flat head to roll lip over the pedals was def a pita and a lot of sweat in a uncomfortable position
Similar threads
