Mounting the 10 pin connectors on 93 Cobra intake??

[90topdown]

In the process of putting an original 93 Cobra intake on my 90.

For those of you that have done this swap before, how did you mount the 2- 10 pin connectors?? There is no place for them to snap on to like they do on the stock manifold.



Thanks

 

[BK_CAULEY]

just let them hang back there. they will be ok.

 

[fox racer]

just let them hang back there. they will be ok.

That's what I did. Although, I did have after market ones and they had a spot for them to clip on, but my clips were broken, so I just left them behind the manifold nicely tucked away and never had a problem.

 

[Mustang5L5]

I just tucked mine down the back.

But there is a spot for them. There's a little ridge next to the EGR port to clip them too. That's how it was on my Ford Racing intake. IIRC it had an F3 part number so i think it was the same as OEM

 

[cevtv]

I just tucked mine down the back.

But there is a spot for them. There's a little ridge next to the EGR port to clip them too. That's how it was on my Ford Racing intake. IIRC it had an F3 part number so i think it was the same as OEM

Yep, the OEM '93 has the spot to clip them on.

 

[90topdown]

Yep, the OEM '93 has the spot to clip them on.

I'll have to take a closer look. Sounds like it is there. I just didn't see it.