Good looking bay. What are you using on the Explorer upper to hold the engine harness plugs?
the mark rotors work ok with the saleens minus the dust cap? i may temp do this i have a chance to get a set for 500 bucks but the correct front end stuff isnt in the budget yettest fitted my front wheels, and finally rolled the car out of the garage , The car has Steeda springs on it but it still sit's way too high so i'm ordering some LRS lowering springs this week to drop it further and also going to put on the sn95 spindles
LEG HUMP LEG HUMP LEG HUMP LEG HUMp..... Ah much better continue to post pics!
the mark rotors work ok with the saleens minus the dust cap? i may temp do this i have a chance to get a set for 500 bucks but the correct front end stuff isnt in the budget yet
Wow that is high for Steeda springs. I've got Steeda Sport springs and they sit much lower than that.
the mark rotors work ok with the saleens minus the dust cap? i may temp do this i have a chance to get a set for 500 bucks but the correct front end stuff isnt in the budget yet
test fitted my front wheels, and finally rolled the car out of the garage , The car has Steeda springs on it but it still sit's way too high so i'm ordering some LRS lowering springs this week to drop it further and also going to put on the sn95 spindles
The springs on mine are the LRS red SVE they say not for convert but they sure do work weel and ride height is on the money!!!
I am talking the dust cap to the saleen wheel with them I no they will work the rotors I just want to know if I can run the saleens with the cap until I do 94-95 5 lug front setupAre you talking Mark7 rotors?
Will those go onto a Fox spindle, or do you need the Mark spindles/calipers as well as the rotors?