What did you do for your Fox today?

[fivespeedsteed]

yeah i need a temp gun to shoot at it to figure it out. might look into a police fan clutch. mine used to only run 2 or 3 ticks up on the temp guage till i fixed the temp sensor

 

[TenorPlayinGuy]

Made mine blow cold air through the vents again!

 

[strattoc]

Made mine blow cold air through the vents again!

Please tell me your secret! Just kidding I would have to have a/c for my car to blow cold. I'd be happy with heat also.

 

[1989DropTop]

Installed Oil Pressure Gauge, Water temp Gauge and Volt Gauge and ordered a bunch of parts from Cj's as they have free shipping this weekend and 20%off Sale!

 

[FoxVerts]

Dusted off the SSP for an All-Ford Show tomorrow.

 

[1bad67sbf]

i seen a few SSP's at the all ford show in PA this morning.

 

[LarsD]

Just put new rubber Ford floor mats in my hatch. You could actually see daylight through the old mats. lol

 

[strattoc]

I just messed up some window tint! window tint can lick my butt hole, all of it looks fine except for the hatch and I knew I should have shrunk it first but I was being stubborn and figured the hatch wasnt that curved..... oh well.

 

[stangrod2000]

got my rear fenders rolled. no more chewing up the drag radials!!

 

[93project]

I installed new rear upper and lower control arms since I grenanded my old Mac ones. Car feels SOOO. Much better now

 

[aar0s]

I replaced a couple of worn out rad hoses and took her for a night time drive with the top down, whacked a cicada and tomorrow Ill be washing bug guts off of it. I hate summer.

 

[kck351w]

i got an x-pipe and possibly some cherry bombs

 

[mg92calypso]

FINALLY got the hood lines looking good. gotta love fiberglass! and she is finally burried in primer. running a little behind my original schedule but will be ready for paint in a couple of days.

 

[FoxVerts]

I installed some GTS smoked covers on the under bumper wig-wag driving lights. I also talked to the original owner who bought the SSP at auction in 1993 and found out it has had the factory exhaust replaced with NOS, had the factory 2:73 gears replaced with 3:55 set, had the factory heater core replaced, and that it was repainted in 1997.

 

[NIKwoaC]

I helped the AAA guy load it onto the back of his tow truck, then I helped him unload it into my garage.



Popped my alternator charge cable fuse, and it is 100% my own damn fault.

 

[FoxVerts]

Installed the correct factory base am/fm radio in my SSP.

 

[SMOKEDYA]

peace













john

 

[SMOKEDYA]

Was a good week for my white 90.

I got a used IAC idle plate ($10) the car idles like a champ now, so happy.
I got a clutch quadrant and firewall adjuster as a freebie from my homies.
I just got home with a new pro 5.0 for 100 bucks for the 3550, it is missing the stop bolts but many say not to use the stops. Not sure what I think about not using the shifter stops... may grab some bolts before I install it tomorrow.

View attachment 186950
Got the gears, gears install kit and bearing ready to go for the 3.55 install next week.

Just need some non stock LCA's an I will call it good....

TKO 3550 have built in stops in the trans,i dont use my stops on my tri-ax shifter and no problems yet! peace










john

 

[ReefBlueHatch]

I finished up my 5-lug swap this weekend.

 

[Riverart]

Man those FR500s look so good. Congrats.