My Project III unit (formerly RetroTek) just arrived. Instructions say that to be self priming the fuel pump must be located below the level of the fuel tank and within 2 feet of it. Pretty limited choices there, and I don't think drilling into the rear frame rails to mount it there would be a good idea (then again, what do I know
Some of you have done this before. Where have you put the fuel pump? Maybe fabricate a bracket that drops it down low enough? Also a bit concerned for the possibility of damage from crap kicking up off the road.
(This is a "returnless" system, so at least the fuel lines will be pretty straightforward)
Thx
Phil
Some of you have done this before. Where have you put the fuel pump? Maybe fabricate a bracket that drops it down low enough? Also a bit concerned for the possibility of damage from crap kicking up off the road.
(This is a "returnless" system, so at least the fuel lines will be pretty straightforward)
Thx
Phil